Difficulty
Moderate
Steps
4
Time Required
25 - 35 minutes
Sections
1
- Front Facing Camera
- 4 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackOnePlus 6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Facing Camera
- Use a heat gun to gently heat the back edges of the phone to loosen the adhesive.
- Use a plastic opening tool to pry the back cover up.
- Start from one of the left corners and work your way around the phone using the plastic opening tool.
- Carefully lift the back cover off.
- Be careful not to damage or unseat the camera cable while removing the back cover.
Use a heat gun to gently heat the back edges of the phone to loosen the adhesive.
Use a plastic opening tool to pry the back cover up.
Start from one of the left corners and work your way around the phone using the plastic opening tool.
Carefully lift the back cover off.
Be careful not to damage or unseat the camera cable while removing the back cover.
1024
Step 2
- Use tweezers to disconnect the red pull-away tab up from the motherboard.
- Detach the orange camera ribbon cable, below the red tab, using the tweezers.
- Grip the green tab and lift the battery up and out of the chassis.
Use tweezers to disconnect the red pull-away tab up from the motherboard.
Detach the orange camera ribbon cable, below the red tab, using the tweezers.
Grip the green tab and lift the battery up and out of the chassis.
Step 3
- Use a Phillips #000 screwdriver to remove the ten screws from the motherboard harness.
- Pull the motherboard harness up using the tweezers
Use a Phillips #000 screwdriver to remove the ten screws from the motherboard harness.
Pull the motherboard harness up using the tweezers
Step 4
- Use the pointed tip of a spudger to lift the front-facing camera’s pin connection, gently prying on the plug vertically until it completely releases.
- Lift the front-facing camera up and out using tweezers.
Use the pointed tip of a spudger to lift the front-facing camera’s pin connection, gently prying on the plug vertically until it completely releases.
Lift the front-facing camera up and out using tweezers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Andrew Davis
Member since: 02/15/2022
133 Reputation
1 Guide authored
Badges:
3
Team
The Citadel Military College of South Carolina, Team 7-8, Eggleston Spring 2022
Member of The Citadel Military College of South Carolina, Team 7-8, Eggleston Spring 2022
CMCSC-EGGLESTON-S22S7G8
3 Members
3 Guides authored