Difficulty

Moderate

Steps

9

Time Required

                          20 - 35 minutes

Sections

2

  • Back Case
  • 4 steps
  • Hinge Contact Assembly
  • 5 steps

Flags

0

  • BackOne Education Infinity:One

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Case
  • Use a spudger to pry the four rubber pads away from the bottom of the case.
  • Use a Phillips #00 screwdriver to unscrew the four 6.4 mm screws.

Use a spudger to pry the four rubber pads away from the bottom of the case.

Use a Phillips #00 screwdriver to unscrew the four 6.4 mm screws.

1024

Step 2

  • Insert a Jimmy or other prying tool into the seam on the edge of the casing.
  • Trace along the edges of the device until all clips are released.
  • Lift the back case away from the device.

Insert a Jimmy or other prying tool into the seam on the edge of the casing.

Trace along the edges of the device until all clips are released.

Lift the back case away from the device.

Step 3

  • Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws on the hinge mounts.

Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws on the hinge mounts.

Step 4

  • Use tweezers to lift the fabric cover and hinge connector away from the daughterboard.
  • Always use ESD safe tools when working with delicate electrical components.

Use tweezers to lift the fabric cover and hinge connector away from the daughterboard.

Always use ESD safe tools when working with delicate electrical components.

Step 5

              Hinge Contact Assembly
  • Lift the hinge away from the device.

Lift the hinge away from the device.

Step 6

  • Use a Phillips #00 screwdriver to unscrew the two 6.5mm screws.

Use a Phillips #00 screwdriver to unscrew the two 6.5mm screws.

Step 7

  • Slide a Jimmy or other prying tool along the seam of the hinge to pry the casing apart.

Slide a Jimmy or other prying tool along the seam of the hinge to pry the casing apart.

Step 8

  • Use a Phillips #00 screwdriver to remove the two 4.3mm screws holding the circuit board in place.

Use a Phillips #00 screwdriver to remove the two 4.3mm screws holding the circuit board in place.

Step 9

  • Use a spudger to pry the circuit board away from the casing.
  • Always use ESD safe tools when removing delicate components.

Use a spudger to pry the circuit board away from the casing.

Always use ESD safe tools when removing delicate components.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Taylor Bratsch

Member since: 09/06/2016

5,438 Reputation

                                      14 Guides authored                  



                       Badges:
                       32







                                                        +29 more badges

Nathan Joyce - Nov 27, 2018

Reply

Everything is very detailed and shown. Everything is also done in detail on this site ++https://oceanessay.com/buy-thesis-pape… , which helps students learn. There you will find a lot of educational materials.