Difficulty

Moderate

Steps

7

Time Required

                          7 - 20 minutes

Sections

2

  • Battery
  • 4 steps
  • Dock Contact Assembly
  • 3 steps

Flags

0

  • BackOne Education Infinity:One

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use a spudger to disconnect the black bundled cable connector from the motherboard.

Use a spudger to disconnect the black bundled cable connector from the motherboard.

1024

Step 2

  • Use a spudger to lift the black tab on top of the ZIF connector.
  • Slide the ribbon cable out of the connector.

Use a spudger to lift the black tab on top of the ZIF connector.

Slide the ribbon cable out of the connector.

Step 3

  • Use a spudger to flip up the black retaining flap on the ZIF connector.
  • Pull the folded ribbon cable straight out of the connector.
  • This ribbon cable must be disconnected before removing the battery because it is attached to the battery with adhesive.

Use a spudger to flip up the black retaining flap on the ZIF connector.

Pull the folded ribbon cable straight out of the connector.

This ribbon cable must be disconnected before removing the battery because it is attached to the battery with adhesive.

Step 4

  • Use a spudger to pry the battery away from the device.
  • Always use ESD safe tools when working with delicate electrical components.

Use a spudger to pry the battery away from the device.

Always use ESD safe tools when working with delicate electrical components.

Step 5

              Dock Contact Assembly
  • Use tweezers to pull the dock contact display cable away from the connector on the motherboard.

Use tweezers to pull the dock contact display cable away from the connector on the motherboard.

Step 6

  • Use a Phillips #000 screwdriver to unscrew the two 4.2mm screws from the circuit board containing the dock contact.

Use a Phillips #000 screwdriver to unscrew the two 4.2mm screws from the circuit board containing the dock contact.

Step 7

  • Lift the dock contact assembly away from the device.

Lift the dock contact assembly away from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Taylor Bratsch

Member since: 09/06/2016

5,438 Reputation

                                      14 Guides authored                  



                       Badges:
                       32







                                                        +29 more badges