Difficulty

Moderate

Steps

7

Time Required

                          10 - 20 minutes

Sections

2

  • Back Case
  • 4 steps
  • Daughterboard
  • 3 steps

Flags

0

  • BackOne Education Infinity:One

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Case
  • Use a spudger to pry the four rubber pads away from the bottom of the case.
  • Use a Phillips #00 screwdriver to unscrew the four 6.4 mm screws.

Use a spudger to pry the four rubber pads away from the bottom of the case.

Use a Phillips #00 screwdriver to unscrew the four 6.4 mm screws.

1024

Step 2

  • Insert a Jimmy or other prying tool into the seam on the edge of the casing.
  • Trace along the edges of the device until all clips are released.
  • Lift the back case away from the device.

Insert a Jimmy or other prying tool into the seam on the edge of the casing.

Trace along the edges of the device until all clips are released.

Lift the back case away from the device.

Step 3

  • Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws on the hinge mounts.

Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws on the hinge mounts.

Step 4

  • Use tweezers to lift the fabric cover and hinge connector away from the daughterboard.
  • Always use ESD safe tools when working with delicate electrical components.

Use tweezers to lift the fabric cover and hinge connector away from the daughterboard.

Always use ESD safe tools when working with delicate electrical components.

Step 5

              Daughterboard
  • Flip up the black retaining flap on the ZIF connector holding the large grey ribbon cable in place.
  • Pull the ribbon cable straight out of the ZIF connector.

Flip up the black retaining flap on the ZIF connector holding the large grey ribbon cable in place.

Pull the ribbon cable straight out of the ZIF connector.

Step 6

  • Use the flat end of a spudger to flip up the black tab on the smaller ZIF connector.
  • Use tweezers to pull the ribbon cable straight out of the connector.

Use the flat end of a spudger to flip up the black tab on the smaller ZIF connector.

Use tweezers to pull the ribbon cable straight out of the connector.

Step 7

  • Use a Phillips #000 screwdriver to unscrew the three 3.4mm screws.
  • Lift the daughterboard away from the device to remove.

Use a Phillips #000 screwdriver to unscrew the three 3.4mm screws.

Lift the daughterboard away from the device to remove.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Taylor Bratsch

Member since: 09/06/2016

5,438 Reputation

                                      14 Guides authored                  



                       Badges:
                       32







                                                        +29 more badges