Difficulty
Easy
Steps
8
Time Required
15 minutes
Sections
2
- Back Panel
- 5 steps
- Front- Facing Camera
- 3 steps
Flags
0
BackOnda V701
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Ensure device is powered off before disassembly.
- Remove the 4 rubber screw plugs using a spudger.
Ensure device is powered off before disassembly.
Remove the 4 rubber screw plugs using a spudger.
1024
Step 2
- Remove the four 4.8mm mounting screws using a PH00 screwdriver.
Remove the four 4.8mm mounting screws using a PH00 screwdriver.
Step 3
- Starting at one corner, gently pry the back panel assembly from the screen assembly using two plastic opening tools.
- Slide the opening tools around the perimeter of the device to separate the back panel assembly from the screen assembly.
Starting at one corner, gently pry the back panel assembly from the screen assembly using two plastic opening tools.
Slide the opening tools around the perimeter of the device to separate the back panel assembly from the screen assembly.
Step 4
- Gently lift the screen assembly away from the back cover assembly.
- Be careful when separating the two pieces as the screen assembly is still connected to the mother board by two ribbon cables.
Gently lift the screen assembly away from the back cover assembly.
Be careful when separating the two pieces as the screen assembly is still connected to the mother board by two ribbon cables.
Step 5
- Disconnect the two ribbon connectors by flipping the gray tabs up with a fingernail or a spudger.
- Remove the ribbon cables.
Disconnect the two ribbon connectors by flipping the gray tabs up with a fingernail or a spudger.
Remove the ribbon cables.
Step 6
Front- Facing Camera
- Gently pry the front-facing camera away from the back panel using a spudger.
Gently pry the front-facing camera away from the back panel using a spudger.
Step 7
- Flip the gray locking tab of the ribbon connector up using a spudger.
- Remove the ribbon cable from the connector.
Flip the gray locking tab of the ribbon connector up using a spudger.
Remove the ribbon cable from the connector.
Step 8
- Remove the front-facing camera assembly.
Remove the front-facing camera assembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Bradley Huber
Member since: 03/11/2015
366 Reputation
3 Guides authored
Badges:
14
+11 more badges
Team
Colorado Springs, Team 4-6, Panko Spring 2015
Member of Colorado Springs, Team 4-6, Panko Spring 2015
UCCS-PANKO-S15S4G6
3 Members
10 Guides authored
