Difficulty
Moderate
Steps
8
Time Required
30 minutes
Sections
3
- Front Plate
- 3 steps
- Back Plate
- 1 step
- Power Button
- 4 steps
Flags
1
Inconsistent Images
Updating the images on this guide to be more consistent with the prerequisites would increase its awesomeness.
BackOlympus VR-350
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Plate
- Remove the two 4mm screws from each side of the camera with a Phillips PH000 screwdriver.
Remove the two 4mm screws from each side of the camera with a Phillips PH000 screwdriver.
1024
Step 2
- Remove the four 4mm screws from the bottom of the camera with a Phillips PH000 screwdriver.
Remove the four 4mm screws from the bottom of the camera with a Phillips PH000 screwdriver.
Step 3
- Use the plastic opening tools and your fingers to pry the front plate from the camera.
- You might need to open the battery cover to remove the front plate.
Use the plastic opening tools and your fingers to pry the front plate from the camera.
You might need to open the battery cover to remove the front plate.
Step 4
Back Plate
- Use your fingers to pry open the back cover.
- When you remove the back of the camera, the button membrane might fall out. Don’t lose this sheet.
- The LCD screen is connected to the body of the camera by an orange ribbon cable. Don’t pull this ribbon cable out.
Use your fingers to pry open the back cover.
When you remove the back of the camera, the button membrane might fall out. Don’t lose this sheet.
The LCD screen is connected to the body of the camera by an orange ribbon cable. Don’t pull this ribbon cable out.
Step 5
Power Button
- Remove the silver panel from the top of the camera.
Remove the silver panel from the top of the camera.
Step 6
- Flip the silver panel over. The power button is the smaller button covered by a metal backing.
Flip the silver panel over. The power button is the smaller button covered by a metal backing.
Step 7
- Pull the metal backing away from the silver panel.
Pull the metal backing away from the silver panel.
Step 8
- Push the power button down and out of the silver panel with your finger.
Push the power button down and out of the silver panel with your finger.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 1 other contributor
Adri
Member since: 02/23/2015
453 Reputation
3 Guides authored
Badges:
12
+9 more badges
Team
USF Tampa, Team 1-3, Leahy Winter 2015
Member of USF Tampa, Team 1-3, Leahy Winter 2015
USFT-LEAHY-W15S1G3
3 Members
10 Guides authored