Difficulty
Moderate
Steps
7
Time Required
15 - 30 minutes
Sections
3
- Front Plate
- 3 steps
- Back Plate
- 1 step
- LCD Screen
- 3 steps
Flags
1
Inconsistent Images
Updating the images on this guide to be more consistent with the prerequisites would increase its awesomeness.
BackOlympus VR-350
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Plate
- Remove the two 4mm screws from each side of the camera with a Phillips PH000 screwdriver.
Remove the two 4mm screws from each side of the camera with a Phillips PH000 screwdriver.
1024
Step 2
- Remove the four 4mm screws from the bottom of the camera with a Phillips PH000 screwdriver.
Remove the four 4mm screws from the bottom of the camera with a Phillips PH000 screwdriver.
Step 3
- Use the plastic opening tools and your fingers to pry the front plate from the camera.
- You might need to open the battery cover to remove the front plate.
Use the plastic opening tools and your fingers to pry the front plate from the camera.
You might need to open the battery cover to remove the front plate.
Step 4
Back Plate
- Use your fingers to pry open the back cover.
- When you remove the back of the camera, the button membrane might fall out. Don’t lose this sheet.
- The LCD screen is connected to the body of the camera by an orange ribbon cable. Don’t pull this ribbon cable out.
Use your fingers to pry open the back cover.
When you remove the back of the camera, the button membrane might fall out. Don’t lose this sheet.
The LCD screen is connected to the body of the camera by an orange ribbon cable. Don’t pull this ribbon cable out.
Step 5
LCD Screen
- Using the Phillips PH000 screwdriver, remove the 4mm screw from the bottom left corner of the button plate located under the button membrane.
Using the Phillips PH000 screwdriver, remove the 4mm screw from the bottom left corner of the button plate located under the button membrane.
Step 6
- Pull the button pad up to fully reveal the visible ribbon cable.
- You might need to bend the button pad out of the way.
Pull the button pad up to fully reveal the visible ribbon cable.
You might need to bend the button pad out of the way.
Step 7
- Pull out the LCD screen and the ribbon cable.
- The ribbon cable should be easy to pull out.
Pull out the LCD screen and the ribbon cable.
The ribbon cable should be easy to pull out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Chloe
Member since: 02/23/2015
112 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
USF Tampa, Team 1-3, Leahy Winter 2015
Member of USF Tampa, Team 1-3, Leahy Winter 2015
USFT-LEAHY-W15S1G3
3 Members
10 Guides authored