Olympus Stylus Tough 8010 Side Panel Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          10 - 15 minutes            

Sections

1

• Side Panel
• 5 steps

Flags

0

• BackOlympus Stylus Tough-8010

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Side Panel               

• Remove the three screws (3.2mm) from the front panel using a T-6 screwdriver.
• Take off the smaller front panel cover.
• Carefully remove the larger front cover.

Remove the three screws (3.2mm) from the front panel using a T-6 screwdriver.

Take off the smaller front panel cover.

Carefully remove the larger front cover.

1024

Step 2

• Remove the top two screws (4.1mm) using a #000 Phillips head screwdriver.
• Remove the two screws (7.9mm) near the control pad. Set metal connector aside.
• Remove the side panel casing.

Remove the top two screws (4.1mm) using a #000 Phillips head screwdriver.

Remove the two screws (7.9mm) near the control pad. Set metal connector aside.

Remove the side panel casing.

Step 3

• Using a #000 Philips head screwdriver, remove the two screws (4.1mm) on the right side of the camera.
• Remove the two screws (4.1mm) from the bottom of the camera.
• Remove the single screw (3.2mm) from the front of the camera.

Using a #000 Philips head screwdriver, remove the two screws (4.1mm) on the right side of the camera.

Remove the two screws (4.1mm) from the bottom of the camera.

Remove the single screw (3.2mm) from the front of the camera.

Step 4

• Carefully remove the front panel piece.
• Remove the screw (7.9mm) from the bottom left hand corner using a #000 Phillips head screwdriver.

Carefully remove the front panel piece.

Remove the screw (7.9mm) from the bottom left hand corner using a #000 Phillips head screwdriver.

Step 5

• Slightly bend the metal that is covering the side panel axle.
• Using a paperclip, completely push out the metal bar that holds the side panel to the camera.
• Remove the side panel door.

Slightly bend the metal that is covering the side panel axle.

Using a paperclip, completely push out the metal bar that holds the side panel to the camera.

Remove the side panel door.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    James G Payne                     

Member since: 03/23/2015

225 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Baylor, Team 7-15, Williams Spring 2015                        

                                                  Member of Baylor, Team 7-15, Williams Spring 2015 



                    BU-WILLIAMS-S15S7G15                     


                                            3 Members                     


                                            12 Guides authored