Difficulty
Difficult
Steps
8
Time Required
15 - 20 minutes
Sections
4
- Disassembling Olympus Stylus 725 SW Back Panel
- 2 steps
- Front Panel
- 1 step
- Side Panels
- 2 steps
- Lens
- 3 steps
Flags
1
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackOlympus Stylus 725 SW
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disassembling Olympus Stylus 725 SW Back Panel
- Remove the four 3 mm long cover screws at the corners of the camera using a Phillips #00 screwdriver.
- Remove the 2 mm long screws securing the sides of the camera which holds the back panel using a Phillips #00 screwdriver.
Remove the four 3 mm long cover screws at the corners of the camera using a Phillips #00 screwdriver.
Remove the 2 mm long screws securing the sides of the camera which holds the back panel using a Phillips #00 screwdriver.
1024
Step 2
- Be careful when removing the back cover; you will need to detach the connecting ribbons. Use tweezers if necessary.
- Detach the ribbons using your thumb, sliding them out of their slots.
- Set the back panel face up to keep the ribbons from touching anything.
Be careful when removing the back cover; you will need to detach the connecting ribbons. Use tweezers if necessary.
Detach the ribbons using your thumb, sliding them out of their slots.
Set the back panel face up to keep the ribbons from touching anything.
Step 3
Front Panel
- Remove the top screws using a 1.5 mm screwdriver.
- Remove the single side screw located on the side of the camera where the tab is, using a #00 screwdriver.
Remove the top screws using a 1.5 mm screwdriver.
Remove the single side screw located on the side of the camera where the tab is, using a #00 screwdriver.
Step 4
Side Panels
- Using a #00 Philips Head Screwdriver, remove the screws located on all four sides of the camera.
Using a #00 Philips Head Screwdriver, remove the screws located on all four sides of the camera.
Step 5
- After removing all four of the screws, pry the side covers off of the camera.
After removing all four of the screws, pry the side covers off of the camera.
Step 6
Lens
- Unscrew four 2mm long screws using the #00 Phillips screwdriver.
Unscrew four 2mm long screws using the #00 Phillips screwdriver.
Step 7
- Remove four metal tabs from corners where the 2mm long screws were attached using tweezers.
Remove four metal tabs from corners where the 2mm long screws were attached using tweezers.
Step 8
- Remove the viewfinder lens using a prying device.
- There will be two ribbons attached to the viewfinder. Remove the ribbons by sliding them off the viewfinder with your thumb.
Remove the viewfinder lens using a prying device.
There will be two ribbons attached to the viewfinder. Remove the ribbons by sliding them off the viewfinder with your thumb.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Bobby Hodges
Member since: 04/18/2010
49 Reputation
6 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 33-71, Johann Spring 2010
Member of Cal Poly, Team 33-71, Johann Spring 2010
CPSU-JOHANN-S10S33G71
4 Members
6 Guides authored