Olympus Stylus 1030 Sw Camera Disassembly Repair Guide

Difficulty

Moderate

Steps

11

Time Required

                          20 - 25 minutes            

Sections

1

• Olympus Stylus 1030 SW Camera Disassembly
• 11 steps

Flags

0

• BackOlympus Stylus 1030 SW

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Before you begin disassembling, be sure to remove the SD card and the battery from the camera.

What you need

Step 1

              Olympus Stylus 1030 SW Camera Disassembly               

• Using the iFixit Opening Tool, pry off the plastic part of the lens.
• Using the T6 Torx screwdriver, unscrew the three screws.

Using the iFixit Opening Tool, pry off the plastic part of the lens.

Using the T6 Torx screwdriver, unscrew the three screws.

1024

Step 2

• Using the Phillips #00 screwdriver, unscrew the three screws.
• Carefully swivel the metal cover out towards you.
• Using tweezers, remove the metal washer.

Using the Phillips #00 screwdriver, unscrew the three screws.

Carefully swivel the metal cover out towards you.

Using tweezers, remove the metal washer.

Step 3

• Using the tweezers, slowly peel off the plate.

Using the tweezers, slowly peel off the plate.

Step 4

• Using the Phillips #00 screwdriver, unscrew the two screws on the side of the camera.

Using the Phillips #00 screwdriver, unscrew the two screws on the side of the camera.

Step 5

• On the opposite side, use the Phillips #00 screwdriver to unscrew both screws.
• Take out the speaker plate.
• Open the multi-connector cover and slide off the side panel.

On the opposite side, use the Phillips #00 screwdriver to unscrew both screws.

Take out the speaker plate.

Open the multi-connector cover and slide off the side panel.

Step 6

• Using the Phillips #00 screwdriver, unscrew the screw above the speaker.
• On the bottom side of the camera, unscrew the two screws.

Using the Phillips #00 screwdriver, unscrew the screw above the speaker.

On the bottom side of the camera, unscrew the two screws.

Step 7

• Open the battery compartment cover.
• Use the Phillips #00 screwdriver to unscrew the screw in the battery compartment.

Open the battery compartment cover.

Use the Phillips #00 screwdriver to unscrew the screw in the battery compartment.

Step 8

• On the front of the camera, unscrew the two screws shown.
• Gently pull on the side until the camera is separated from the back panel.
• Remove the shutter and power button.

On the front of the camera, unscrew the two screws shown.

Gently pull on the side until the camera is separated from the back panel.

Remove the shutter and power button.

Step 9

• Use the Phillips #00 screwdriver to unscrew the four screws on the front of the camera.
• Unscrew the shutter using the Phillips #00 screwdriver.

Use the Phillips #00 screwdriver to unscrew the four screws on the front of the camera.

Unscrew the shutter using the Phillips #00 screwdriver.

Step 10

• Release the top holding using a spudger.
• Slowly and carefully separate the front and back of the camera, exposing the electrical ribbons.

Release the top holding using a spudger.

Slowly and carefully separate the front and back of the camera, exposing the electrical ribbons.

Step 11

• Using the spudger and tweezers if needed, remove the ribbons from the computer chips.

Using the spudger and tweezers if needed, remove the ribbons from the computer chips.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 12 other contributors 

                    Shanmei Zheng                     

Member since: 02/17/2014

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       6





                                                        +3 more badges                           

Team

                       University of Illinois Urbana-Champaign, Team 1-2, Scrogum Spring 2014                        

                                                  Member of University of Illinois Urbana-Champaign, Team 1-2, Scrogum Spring 2014 



                    UICU-SCROGUM-S14S1G2                     


                                            5 Members                     


                                            10 Guides authored