Featured
Featured Guide
Difficulty
Moderate
Steps
10
Time Required
5 - 10 minutes
Sections
2
- Disassembling Olympus Stylus 1010 Case
- 7 steps
- LCD Display
- 3 steps
Flags
1
Featured Guide
This guide has been found to be exceptionally cool by the iFixit staff.
BackOlympus Stylus 1010
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disassembling Olympus Stylus 1010 Case
- Remove the five Phillips #00 bottom and right side panel screws.
Remove the five Phillips #00 bottom and right side panel screws.
1024
Step 2
- Remove the right side panel by pulling off the large silver piece.
Remove the right side panel by pulling off the large silver piece.
Step 3
- Remove the remaining three Phillips #00 side and front panel screws.
Remove the remaining three Phillips #00 side and front panel screws.
Step 4
- Using your thumb and forefinger, pull off the silver name plate and silver “T-shape” piece.
Using your thumb and forefinger, pull off the silver name plate and silver “T-shape” piece.
Step 5
- Remove the black front panel by sliding it towards the lens and then pulling it up off of the camera.
Remove the black front panel by sliding it towards the lens and then pulling it up off of the camera.
Step 6
- Remove the three Phillips #00 screws from the front of the camera.
- Using a spudger, lift the two tabs to separate the case—one tab on top and one tab on the right side.
Remove the three Phillips #00 screws from the front of the camera.
Using a spudger, lift the two tabs to separate the case—one tab on top and one tab on the right side.
Step 7
- Using a plastic spudger, lift up the black clips.
- Still using the plastic spudger, detach the gold connector strip and white connector strip.
- Using both hands, pull the camera apart into two pieces.
Using a plastic spudger, lift up the black clips.
Still using the plastic spudger, detach the gold connector strip and white connector strip.
Using both hands, pull the camera apart into two pieces.
Step 8
LCD Display
- Peel up the blue and black tape. This can be done with a spudger.
Peel up the blue and black tape. This can be done with a spudger.
Step 9
Step 10
- Push out the LCD screen by pushing on the screen side.
Push out the LCD screen by pushing on the screen side.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 7 other contributors
Curtis Reedy
Member since: 01/12/2011
267 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team 13-4, Forte Winter 2011
Member of Cal Poly, Team 13-4, Forte Winter 2011
CPSU-FORTE-W11S13G4
6 Members
12 Guides authored