Olympus Om D E M10 Mark Ii Hdmi And Multi Connector Cover Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

HDMI and Multi-connector Cover
5 steps

Flags

BackOlympus OM-D E-M10 Mark II
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              HDMI and Multi-connector Cover

There are three different types and lengths of screws used to hold the bottom plate of the camera. Make proper note of each screws original position during your disassembly.
Using the PH00 Phillips-head screwdriver, unscrew the two 1/3 inch screws with silver threads from the the bottom of the camera.
Using the PH00 Phillips-head screwdriver, unscrew the three 1/3 inch screws with blue threads from the the bottom of the camera.
Using the PH00 Phillips-head screwdriver, unscrew the three 1/2 inch screws with silver threads from the the bottom of the camera.

There are three different types and lengths of screws used to hold the bottom plate of the camera. Make proper note of each screws original position during your disassembly.

Using the PH00 Phillips-head screwdriver, unscrew the two 1/3 inch screws with silver threads from the the bottom of the camera.

Using the PH00 Phillips-head screwdriver, unscrew the three 1/3 inch screws with blue threads from the the bottom of the camera.

Using the PH00 Phillips-head screwdriver, unscrew the three 1/2 inch screws with silver threads from the the bottom of the camera.

1024

Step 2

After removing all of the screws, remove the bottom plate from the camera to continue.

After removing all of the screws, remove the bottom plate from the camera to continue.

Step 3

Continuing to use the size PH00 Phillips-head screwdriver, remove the two 3/5 inch screws revealed after removing the bottom plate of the camera.

Continuing to use the size PH00 Phillips-head screwdriver, remove the two 3/5 inch screws revealed after removing the bottom plate of the camera.

Step 4

Open the HDMI connector door and continue to use the PH00 Phillips-head screwdriver to remove the 3/10 inch screw located underneath the door.

Open the HDMI connector door and continue to use the PH00 Phillips-head screwdriver to remove the 3/10 inch screw located underneath the door.

Step 5

Proper removal of all 11 screws listed in the steps above from the camera gives the camera the ability to be opened slightly and allows for the door to be lifted off of the hooks holding it in place within the camera.

Proper removal of all 11 screws listed in the steps above from the camera gives the camera the ability to be opened slightly and allows for the door to be lifted off of the hooks holding it in place within the camera.

To add your new HDMI connector door, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Allen Anjal

Member since: 09/27/2016

317 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       USF Tampa, Team S5-G6, Eyestone Spring 2018                        

                                                  Member of USF Tampa, Team S5-G6, Eyestone Spring 2018 



                    USFT-EYESTONE-S18S5G6                     


                                            4 Members                     


                                            10 Guides authored

Raffy Martinez - Sep 23, 2022

so, where can I buy the port cover or door for the OMD-em10 mark2? Thanks

Introduction#

What you need#

Team#

Introduction

What you need

Team