Difficulty
Moderate
Steps
5
Time Required
10 minutes
Sections
1
- Front Case
- 5 steps
Flags
0
BackOlympus Tough TG-3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Case
- Locate the strap eyelet side of the camera and use the PH000 screwdriver to remove the two 5.3mm screws that hold the strap.
Locate the strap eyelet side of the camera and use the PH000 screwdriver to remove the two 5.3mm screws that hold the strap.
1024
Step 2
- Locate the side of the camera containing the HDMI port. Use the PH000 screwdriver to remove the 5.4mm screw located on the lower left side below the port.
Locate the side of the camera containing the HDMI port. Use the PH000 screwdriver to remove the 5.4mm screw located on the lower left side below the port.
Step 3
- Using the PH000 screwdriver, remove the 3.8mm screw located inside the HDMI port.
Using the PH000 screwdriver, remove the 3.8mm screw located inside the HDMI port.
Step 4
- Locate the bottom section of the camera. Using the PH000 screwdriver, remove the two 4mm screws located towards the middle (near the battery compartment).
Locate the bottom section of the camera. Using the PH000 screwdriver, remove the two 4mm screws located towards the middle (near the battery compartment).
Step 5
- Now you should be able to remove the front case easily using your hand.
Now you should be able to remove the front case easily using your hand.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Natalia Morales
Member since: 10/11/2016
675 Reputation
5 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 1-6, Leahy Fall 2016
Member of USF Tampa, Team 1-6, Leahy Fall 2016
USFT-LEAHY-F16S1G6
3 Members
10 Guides authored