Difficulty

Easy

Steps

3

Time Required

Suggest a time??

Sections

1

  • LCD Screen
  • 3 steps

Flags

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackOlympus C-765

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Over time, the LCD Screen may become damaged, which can cause a disconnect between the displayed image and the photographs being taken.

The guide will show the steps necessary for replacement, including disconnecting ribbon cables.

Take care before beginning by first disconnecting any external power source from the device and ensuring that it is powered off.

What you need

Step 1

              LCD Screen
  • Remove all the screws using your Phillips #00 holding the back plate in place. This includes:
  • On the Back: Unscrew the 4mm screw to the right of the viewfinder.
  • On the Bottom:
  • Unscrew the 3mm screw in the top left corner.
  • Unscrew the four 3mm screws under the battery cover.
  • On the Right Side: Unscrew the one 3mm screw holding the right-side panel.
  • On the Left Side: Unscrew the two 2mm screws holding the left-side panel.

Remove all the screws using your Phillips #00 holding the back plate in place. This includes:

On the Back: Unscrew the 4mm screw to the right of the viewfinder.

On the Bottom:

Unscrew the 3mm screw in the top left corner.

Unscrew the four 3mm screws under the battery cover.

On the Right Side: Unscrew the one 3mm screw holding the right-side panel.

On the Left Side: Unscrew the two 2mm screws holding the left-side panel.

1024

Step 2

  • After you remove the back cover:
  • Gently pull the two ribbon cables out of their sockets.
  • Gently disconnect the white cable.

After you remove the back cover:

Gently pull the two ribbon cables out of their sockets.

Gently disconnect the white cable.

Step 3

  • Peel the black tape off the back of the LCD.
  • Using the Phillips #00 remove the four 3mm screws on the LCD bracket.
  • Remove the two 2mm screws from the top of the bracket.
  • Use a spudger to pop the LCD screen out of the camera’s backplate.
  • When the bracket comes off, the buttons from the top section may fall out of place. If this happens then put them back in the position they were in.

Peel the black tape off the back of the LCD.

Using the Phillips #00 remove the four 3mm screws on the LCD bracket.

Remove the two 2mm screws from the top of the bracket.

Use a spudger to pop the LCD screen out of the camera’s backplate.

When the bracket comes off, the buttons from the top section may fall out of place. If this happens then put them back in the position they were in.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 8 other contributors 


                    Mason Morgan

Member since: 04/05/2011

115 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 12-33, Maness Spring 2011                        

                                                  Member of Cal Poly, Team 12-33, Maness Spring 2011 



                    CPSU-MANESS-S11S12G33                     


                                            3 Members                     


                                            7 Guides authored