Difficulty

Moderate

Steps

5

Time Required

                          40 minutes

Sections

1

  • Vent Engine
  • 5 steps

Flags

0

  • BackOhmeda Engström

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

For more information on removing the vent engine, please refer to page 9-5 (section 9.3.2) in the technical manual.

What you need

Step 1

              Vent Engine
  • With the main chassis separated from the cart, position the device upright with the monitor centered to prevent any tipping.
  • Disconnect any external connectors as well as the display connector.
  • Make sure you are working in a clean and dust-free environment to avoid introducing any unwanted debris to the inside of the device.

With the main chassis separated from the cart, position the device upright with the monitor centered to prevent any tipping.

Disconnect any external connectors as well as the display connector.

Make sure you are working in a clean and dust-free environment to avoid introducing any unwanted debris to the inside of the device.

1024

Step 2

  • Push down on the small grey tab below the exhalation valve.
  • While holding the tab down, you should be able to pull and extract the exhalation valve from the device.

Push down on the small grey tab below the exhalation valve.

While holding the tab down, you should be able to pull and extract the exhalation valve from the device.

Step 3

  • There are four Phillips screws to be removed at each corner of the back of the device.
  • Once the screws are removed, slide the housing along with display to reveal the main chassis.

There are four Phillips screws to be removed at each corner of the back of the device.

Once the screws are removed, slide the housing along with display to reveal the main chassis.

Step 4

  • Remove the circuit board retainer in the upper right by unscrewing the four screws (M4-0.7 x 12mm Phillips) that hold it in place.
  • Disconnect the connectors coming from the vent engine to the circuitry.
  • Avoid any unnecessary contact with circuit board components.

Remove the circuit board retainer in the upper right by unscrewing the four screws (M4-0.7 x 12mm Phillips) that hold it in place.

Disconnect the connectors coming from the vent engine to the circuitry.

Avoid any unnecessary contact with circuit board components.

Step 5

  • The vent engine is held in place by two screws on each side of the device. Unscrew all four and remove the vent engine.
  • Install the new vent engine and screw into place.
  • Connect the vent engine connectors to the circuit board and reinstall the circuit board retainer.

The vent engine is held in place by two screws on each side of the device. Unscrew all four and remove the vent engine.

Install the new vent engine and screw into place.

Connect the vent engine connectors to the circuit board and reinstall the circuit board retainer.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Jonathan Honrada

Member since: 04/10/2020

136 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Cal Poly, Team S7-G6, Paton Spring 2020                        

                                                  Member of Cal Poly, Team S7-G6, Paton Spring 2020 



                    CPSU-PATON-S20S7G6                     


                                            3 Members                     


                                            3 Guides authored