Ohmeda Engstr M Compressor Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 - 45 minutes

Sections

Compressor
4 steps

Flags

BackOhmeda Engström
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

For more information on replacing the compressor, please refer to page 9-31 (section 9.7) in the technical manual.

What you need

Step 1

              Compressor

Ensure the device is powered off and unplugged
Disconnect any wires or components that are plugged in prior to repair

Ensure the device is powered off and unplugged

Disconnect any wires or components that are plugged in prior to repair

1024

Step 2

Tap the back end of a flat head screwdriver with a hammer to wedge the side trim pieces away from the machine.

Tap the back end of a flat head screwdriver with a hammer to wedge the side trim pieces away from the machine.

Step 3

Use the flat head screwdriver to pry off and remove the side panels
When prying off the panels, do so carefully so that you do not to scratch or damage them
When reassembling the side panels, make sure that the connectors snap back into place.
Remove the mounting hardware from the compressor on the cart

Use the flat head screwdriver to pry off and remove the side panels

When prying off the panels, do so carefully so that you do not to scratch or damage them

When reassembling the side panels, make sure that the connectors snap back into place.

Remove the mounting hardware from the compressor on the cart

Step 4

Screw in the service tool to assist in lifting the compressor and sliding out of the cart

Screw in the service tool to assist in lifting the compressor and sliding out of the cart

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Kobe Hayashi

Member since: 02/07/2020

251 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Cal Poly, Team S7-G6, Paton Spring 2020                        

                                                  Member of Cal Poly, Team S7-G6, Paton Spring 2020 



                    CPSU-PATON-S20S7G6                     


                                            3 Members                     


                                            3 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team