Difficulty
Moderate
Steps
4
Time Required
3 - 5 minutes
Sections
2
- Control Box Bottom Cover
- 2 steps
- Control Box Motherboard
- 2 steps
Flags
0
BackOculus Rift Development Kit 1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Control Box Bottom Cover
- Use a plastic opening tool to carefully pry off the four rubber feet from the control box.
- You have now revealed the four 9 mm Phillips #1 screws underneath the rubber feet.
Use a plastic opening tool to carefully pry off the four rubber feet from the control box.
You have now revealed the four 9 mm Phillips #1 screws underneath the rubber feet.
1024
Step 2
- Use a Phillips #1 Screwdriver to unscrew the four 9mm Phillips screws on the bottom of the control box.
- You can now remove the bottom lid of the control box. It should come apart easily.
Use a Phillips #1 Screwdriver to unscrew the four 9mm Phillips screws on the bottom of the control box.
You can now remove the bottom lid of the control box. It should come apart easily.
Step 3
Control Box Motherboard
- Use your finger(s) to start lifting the motherboard from the control box casing. While doing so, use your other hand to push the DVI connector into the control box casing.
- When the DVI connector has cleared the casing, lift the motherboard.
- Be careful! There should be two sets of wires still connected to the control box - do not tug on them. Simply flip the motherboard over to access these wires.
- When reassembling the device, ensure that all of the wires are clear of the buttons.
Use your finger(s) to start lifting the motherboard from the control box casing. While doing so, use your other hand to push the DVI connector into the control box casing.
When the DVI connector has cleared the casing, lift the motherboard.
Be careful! There should be two sets of wires still connected to the control box - do not tug on them. Simply flip the motherboard over to access these wires.
When reassembling the device, ensure that all of the wires are clear of the buttons.
Step 4
- Use a plastic opening tool or your fingernails to disconnect the grey wire connectors. To make removal easier, pry the left and right edges to carefully remove the connector.
- Do so for both of the wires attached to the motherboard.
- Now fully separate the motherboard from the control box casing.
Use a plastic opening tool or your fingernails to disconnect the grey wire connectors. To make removal easier, pry the left and right edges to carefully remove the connector.
Do so for both of the wires attached to the motherboard.
Now fully separate the motherboard from the control box casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Audrey Chan
Member since: 01/12/2015
201 Reputation
2 Guides authored
Badges:
3
Team
Cal Poly, Team 70-5, Forte Winter 2015
Member of Cal Poly, Team 70-5, Forte Winter 2015
CPSU-FORTE-W15S70G5
4 Members
6 Guides authored