Difficulty
Moderate
Steps
9
Time Required
35 minutes
Sections
1
- Bluetooth Controller D-Pad
- 9 steps
Flags
0
BackNvidia Shield Pro Android TV
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bluetooth Controller D-Pad
- Remove the six T6 Torx screws from the back of the controller.
Remove the six T6 Torx screws from the back of the controller.
1024
Step 2
- Gently open the top frame of the cover with the plastic opening tool.
Gently open the top frame of the cover with the plastic opening tool.
Step 3
- Gently pull the wire connector out of its socket, separating the two halves of the controller.
Gently pull the wire connector out of its socket, separating the two halves of the controller.
Step 4
- Remove the wire attached to the circular piece.
Remove the wire attached to the circular piece.
Step 5
- Carefully remove the two T6 Torx screws from either side of the motherboard.
Carefully remove the two T6 Torx screws from either side of the motherboard.
Step 6
- Remove the yellow plug from its socket.
Remove the yellow plug from its socket.
Step 7
- Remove the two T6 Torx screws.
Remove the two T6 Torx screws.
Step 8
- Slowly pull up the primary circuit board of the controller until the D-pad is revealed.
- Carefully remove the board.
Slowly pull up the primary circuit board of the controller until the D-pad is revealed.
Carefully remove the board.
Step 9
- Gently remove and replace the D-Pad.
Gently remove and replace the D-Pad.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Ben Carrasco
Member since: 01/23/2020
327 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
Cal Poly, Team S18-G2, White Winter 2020
Member of Cal Poly, Team S18-G2, White Winter 2020
CPSU-WHITE-W20S18G2
4 Members
6 Guides authored
