Nvidia Shield Display Assembly Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

3

• Battery Assembly
• 4 steps
• Fan
• 1 step
• Display Assembly
• 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackNvidia Shield Portable

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Remove Front Panel               

• Remove the seven 6.4mm T5 Torx screws from the back panel.
• Use the spudger to separate the front and back panels.

Remove the seven 6.4mm T5 Torx screws from the back panel.

Use the spudger to separate the front and back panels.

1024

Step 2

              Remove Green Grill               

• The green grill is not screwed in so it can be pulled right out.

The green grill is not screwed in so it can be pulled right out.

Step 3

              Remove Battery Cables               

• Remove the six 6.5mm T5 Torx screws.
• Disconnect the power wires.
• Peel back the copper tape and disconnect the black and white wires.

Remove the six 6.5mm T5 Torx screws.

Disconnect the power wires.

Peel back the copper tape and disconnect the black and white wires.

Step 4

              Remove Battery Apparatus               

• Pull the battery apparatus out once all cables are removed.

Pull the battery apparatus out once all cables are removed.

Step 5

              Removing Fan               

• Cooling is important for electronics, the last thing they want is to overheat.
• Remove the two 7.3mm and four 8.4mm T5 Torx screws and disconnect the power cable.
• Lift the fan free after the screws and cable are removed.

Cooling is important for electronics, the last thing they want is to overheat.

Remove the two 7.3mm and four 8.4mm T5 Torx screws and disconnect the power cable.

Lift the fan free after the screws and cable are removed.

Step 6

              Disconnecting from logic board               

• On the left side from where the display is attached to the back panel there is one 3.8mm T5 Torx screw that needs to be removed.
• Once removed, the display should be able to be detached.

On the left side from where the display is attached to the back panel there is one 3.8mm T5 Torx screw that needs to be removed.

Once removed, the display should be able to be detached.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.                                             

Author

                                      with 4 other contributors 

                    Noel Fletcher                     

Member since: 09/22/2014

116 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       USF Tampa, Team 1-1, Hickman Fall 2014                        

                                                  Member of USF Tampa, Team 1-1, Hickman Fall 2014 



                    USFT-HICKMAN-F14S1G1                     


                                            4 Members                     


                                            12 Guides authored                     

jorge valenzuela - May 1, 2018

Reply

Where can o get a replacement screen