Difficulty
Moderate
Steps
4
Time Required
30 - 40 minutes
Sections
1
- Rear Camera
- 4 steps
Flags
2
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Missing Prerequisites
This guide is missing information on how to start the process. Make a prerequisite guide!
BackNuVision TM800A510L
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Camera
- Use a Heat Gun to heat the sides of the device one at a time. The Heat Gun will loosen the adhesive.
- Use thin tools to pry the back of the device off.
- Metal tools may work best but may also scratch the device. Plastic prying tools can also be used.
- Be careful around the power and volume buttons.
Use a Heat Gun to heat the sides of the device one at a time. The Heat Gun will loosen the adhesive.
Use thin tools to pry the back of the device off.
Metal tools may work best but may also scratch the device. Plastic prying tools can also be used.
Be careful around the power and volume buttons.
1024
Step 2
- There are two different cameras and each have different ribbons.
- Unlock both ribbons by flipping the black bar up.
There are two different cameras and each have different ribbons.
Unlock both ribbons by flipping the black bar up.
Step 3
- The camera facing towards the table lifts out easily, so go ahead and take that one out.
- This works out well, if this is the camera you are most concerned about.
- If you are more concerned the one facing you, move on to the next step.
The camera facing towards the table lifts out easily, so go ahead and take that one out.
This works out well, if this is the camera you are most concerned about.
If you are more concerned the one facing you, move on to the next step.
Step 4
- This camera is held down with adhesive, so you must be careful when prying it.
- GO SLOW!
- Camera pulls up and out of its slot easily.
This camera is held down with adhesive, so you must be careful when prying it.
GO SLOW!
Camera pulls up and out of its slot easily.
To reassemble your device, follow these instructions in reverse order.
Be advised that you will need to replace the adhesive.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Kelsey Riggs
Member since: 01/25/2017
486 Reputation
5 Guides authored
Badges:
11
+8 more badges
Team
University of Illinois Urbana-Champaign, Team 1-1, Scrogum Spring 2017
Member of University of Illinois Urbana-Champaign, Team 1-1, Scrogum Spring 2017
UICU-SCROGUM-S17S1G1
3 Members
19 Guides authored