Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

  • Small Rubber Wheel
  • 4 steps
  • Plastic Outer Base
  • 2 steps

Flags

1

Mismatched Prerequisites

This guide does not have a proper prerequisite guide. Help match it to its ideal partner by finding it or writing one!

  • BackNutri Ninja BL450

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Small Rubber Wheel
  • Remove the cup from the blender base.

Remove the cup from the blender base.

1024

Step 2

  • Turn the blender over and unscrew the three 14 mm screws holding the slotted base in place. These are Torx Security bits (TR9) on some units.

Turn the blender over and unscrew the three 14 mm screws holding the slotted base in place. These are Torx Security bits (TR9) on some units.

Step 3

  • Using a the standard Phillips head screwdriver bit, remove the slotted black plastic covering and then unscrew the one 11mm screw holding the power cord in place.
  • Unscrew the four 14 mm screws that are in the deep slots. This will release the motor from the base.

Using a the standard Phillips head screwdriver bit, remove the slotted black plastic covering and then unscrew the one 11mm screw holding the power cord in place.

Unscrew the four 14 mm screws that are in the deep slots. This will release the motor from the base.

Step 4

  • CAUTION: the silver blade attached to the motor is very sharp. Use a towel or thick cloth to protect your hands for the next step.
  • Using a towel, hold the silver fan still. Twist the small black rubber wheel that is attached to the top of the blender base to the right. This will remove the wheel for replacement.

CAUTION: the silver blade attached to the motor is very sharp. Use a towel or thick cloth to protect your hands for the next step.

Using a towel, hold the silver fan still. Twist the small black rubber wheel that is attached to the top of the blender base to the right. This will remove the wheel for replacement.

Step 5

              Plastic Outer Base
  • Use the standard Phillips head screw bit to unscrew the screws in the black plastic with the silver circular discs.
  • Using the T9 screw bit, unscrew the four sets of two 11 mm screws located on each of the four sides of the motor.

Use the standard Phillips head screw bit to unscrew the screws in the black plastic with the silver circular discs.

Using the T9 screw bit, unscrew the four sets of two 11 mm screws located on each of the four sides of the motor.

Step 6

  • Untwist the small rubber connector to detach the plastic from the motor.

Untwist the small rubber connector to detach the plastic from the motor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Morgan Blauth

Member since: 02/24/2016

759 Reputation

                                      5 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       USF Tampa, Team 1-5, Leahy Spring 2016                        

                                                  Member of USF Tampa, Team 1-5, Leahy Spring 2016 



                    USFT-LEAHY-S16S1G5                     


                                            2 Members                     


                                            5 Guides authored