Difficulty

Moderate

Steps

10

Time Required

                          5 - 10 minutes

Sections

1

  • Tone Arm
  • 10 steps

Flags

0

  • BackNumark TT1600

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Tone Arm
  • Flip over the turntable and remove the 9 screws on the outer edges.

Flip over the turntable and remove the 9 screws on the outer edges.

1024

Step 2

  • Remove the back cover by pulling it apart.

Remove the back cover by pulling it apart.

Step 3

  • Remove the clip located on the backside of the audio jack housing by gently pulling it out.
  • There will be some resistance but continue to pull gently.
  • The clip is located right underneath the audio jacks.

Remove the clip located on the backside of the audio jack housing by gently pulling it out.

There will be some resistance but continue to pull gently.

The clip is located right underneath the audio jacks.

Step 4

  • Remove the screw that connects the black wire of the tone arm to the base of the audio jack housing.

Remove the screw that connects the black wire of the tone arm to the base of the audio jack housing.

Step 5

  • Gently pull the wire that you just unscrewed to release it from the clip.

Gently pull the wire that you just unscrewed to release it from the clip.

Step 6

  • Remove the two screws connecting the circuit board to the tone arm.

Remove the two screws connecting the circuit board to the tone arm.

Step 7

  • Remove the two remaining screws connecting the tone arm to the device.

Remove the two remaining screws connecting the tone arm to the device.

Step 8

  • Flip the turntable back over to the top side.
  • Remove the counter weight located at the back of the tone arm.

Flip the turntable back over to the top side.

Remove the counter weight located at the back of the tone arm.

Step 9

  • Push out the pin keeping the tone arm in place using a Phillips #00 screwdriver.
  • Once you have pushed the pin out with the screwdriver, pull the rest of it out using your hand.

Push out the pin keeping the tone arm in place using a Phillips #00 screwdriver.

Once you have pushed the pin out with the screwdriver, pull the rest of it out using your hand.

Step 10

  • Pick up the tone arm and point the back end of it towards its base.
  • Push the back end of the tone arm into the hole.
  • Flip the turntable over and pull the tone arm all the way through the hole.

Pick up the tone arm and point the back end of it towards its base.

Push the back end of the tone arm into the hole.

Flip the turntable over and pull the tone arm all the way through the hole.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 5 other contributors 


                    Nikolai

Member since: 10/12/2011

236 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 17-14, Regan Fall 2011                        

                                                  Member of Cal Poly, Team 17-14, Regan Fall 2011 



                    CPSU-REGAN-F11S17G14                     


                                            4 Members                     


                                            11 Guides authored