Difficulty
Moderate
Steps
10
Time Required
5 - 10 minutes
Sections
2
- Numark N4 Disassembly
- 6 steps
- PCB Circuit Board
- 4 steps
Flags
0
BackNumark N4
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Numark N4 Disassembly
- Turn the Numark N4 over so that the bottom panel is facing upwards.
- Loosen and remove the 17 12mm screws from the bottom panel using a Phillips #2 screwdriver.
Turn the Numark N4 over so that the bottom panel is facing upwards.
Loosen and remove the 17 12mm screws from the bottom panel using a Phillips #2 screwdriver.
1024
Step 2
- Using your fingers, gently pull apart the two panels of the device until you feel resistance from the cables.
Using your fingers, gently pull apart the two panels of the device until you feel resistance from the cables.
Step 3
- Using your fingers, gently unplug the larger ribbon cable as pictured.
Using your fingers, gently unplug the larger ribbon cable as pictured.
Step 4
- Using your fingers, gently unplug the smaller ribbon cable as pictured.
Using your fingers, gently unplug the smaller ribbon cable as pictured.
Step 5
- Using your fingers, gently unplug the yellow and red cable as pictured.
Using your fingers, gently unplug the yellow and red cable as pictured.
Step 6
- Open the two panels completely, gently placing each side on your working area to avoid damage to the buttons on the outside face.
Open the two panels completely, gently placing each side on your working area to avoid damage to the buttons on the outside face.
Step 7
PCB Circuit Board
- Locate the top right PCB circuit board.
Locate the top right PCB circuit board.
Step 8
- Unplug the two ribbon cables as shown.
Unplug the two ribbon cables as shown.
Step 9
- Loosen and remove the 11 12mm screws from the circuit board using a Phillips #2 screwdriver.
Loosen and remove the 11 12mm screws from the circuit board using a Phillips #2 screwdriver.
Step 10
- Carefully remove the circuit board from its housing.
Carefully remove the circuit board from its housing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 1 other contributor
Erik Charlton
Member since: 10/10/2017
627 Reputation
5 Guides authored
Badges:
13
+10 more badges
Team
USF Tampa, Team S13-G11, Cagle Fall 2017
Member of USF Tampa, Team S13-G11, Cagle Fall 2017
USFT-CAGLE-F17S13G11
4 Members
6 Guides authored