Numark N4 Bp Main Pcb Board Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          5 - 10 minutes            

Sections

2

• Numark N4 Disassembly
• 6 steps
• Numark N4 BP Main PCB Board
• 2 steps

Flags

0

• BackNumark N4

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Numark N4 Disassembly               

• Turn the Numark N4 over so that the bottom panel is facing upwards.
• Loosen and remove the 17 12mm screws from the bottom panel using a Phillips #2 screwdriver.

Turn the Numark N4 over so that the bottom panel is facing upwards.

Loosen and remove the 17 12mm screws from the bottom panel using a Phillips #2 screwdriver.

1024

Step 2

• Using your fingers, gently pull apart the two panels of the device until you feel resistance from the cables.

Using your fingers, gently pull apart the two panels of the device until you feel resistance from the cables.

Step 3

• Using your fingers, gently unplug the larger ribbon cable as pictured.

Using your fingers, gently unplug the larger ribbon cable as pictured.

Step 4

• Using your fingers, gently unplug the smaller ribbon cable as pictured.

Using your fingers, gently unplug the smaller ribbon cable as pictured.

Step 5

• Using your fingers, gently unplug the yellow and red cable as pictured.

Using your fingers, gently unplug the yellow and red cable as pictured.

Step 6

• Open the two panels completely, gently placing each side on your working area to avoid damage to the buttons on the outside face.

Open the two panels completely, gently placing each side on your working area to avoid damage to the buttons on the outside face.

Step 7

              Numark N4 BP Main PCB Board               

• Loosen and remove the five 12mm screws from the circuit board using a Phillips #2 screwdriver.

Loosen and remove the five 12mm screws from the circuit board using a Phillips #2 screwdriver.

Step 8

• Carefully remove the circuit board from its housing.

Carefully remove the circuit board from its housing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Erik Charlton                     

Member since: 10/10/2017

627 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       USF Tampa, Team S13-G11, Cagle Fall 2017                        

                                                  Member of USF Tampa, Team S13-G11, Cagle Fall 2017 



                    USFT-CAGLE-F17S13G11                     


                                            4 Members                     


                                            6 Guides authored