Difficulty
Moderate
Steps
7
Time Required
15 minutes
Sections
3
- Battery
- 2 steps
- Case
- 2 steps
- Circuit Board
- 3 steps
Flags
1
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackNovatel MiFi 2200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the rear cover by pressing down on the cover and pulling it away from the device.
Remove the rear cover by pressing down on the cover and pulling it away from the device.
1024
Step 2
- Place your finger on the back of the battery located near the edge of the device.
- Push your finger into the battery and lift up to pop the battery out of the device.
Place your finger on the back of the battery located near the edge of the device.
Push your finger into the battery and lift up to pop the battery out of the device.
Step 3
Case
- Using a metal spudger, pry open the device around the seam between the front and back cover.
- It may be difficult to split apart, so use force with caution.
- It may seem like you are breaking the device, but you will only be breaking the adhesive lining that keeps the device sealed.
Using a metal spudger, pry open the device around the seam between the front and back cover.
It may be difficult to split apart, so use force with caution.
It may seem like you are breaking the device, but you will only be breaking the adhesive lining that keeps the device sealed.
Step 4
- Once the seal has been broken all the way around, open the cases using your hands.
Once the seal has been broken all the way around, open the cases using your hands.
Step 5
Circuit Board
- To disconnect the antenna, pull up on the antenna’s connection to the circuit board until it pops off.
To disconnect the antenna, pull up on the antenna’s connection to the circuit board until it pops off.
Step 6
- Simply pick up the circuit board with your fingers and remove it from the case.
Simply pick up the circuit board with your fingers and remove it from the case.
Step 7
- Apply double-sided stick tape to the inner top and bottom halves of the device along the seam that was previously unsealed.
- Snap the two halves together along the adhesive line to reconnect it as it previously was.
Apply double-sided stick tape to the inner top and bottom halves of the device along the seam that was previously unsealed.
Snap the two halves together along the adhesive line to reconnect it as it previously was.
After the circuit board is replaced the device should function properly again. When reassembling the device, keep in mind that you will need adhesive to keep the device together.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 7 other contributors
Justin Russo
Member since: 04/15/2012
196 Reputation
3 Guides authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 7-36, Maness Spring 2012
Member of Cal Poly, Team 7-36, Maness Spring 2012
CPSU-MANESS-S12S7G36
5 Members
5 Guides authored
David - Jan 2, 2015
Reply
Hello, where do you purchase the new circuit board?
Clennis Jones - Oct 28, 2016
Reply
I’ve tried every thing to get this device to work properly. Sic results. Sic.
Where and how can I get this thing replaced?