Difficulty
Moderate
Steps
9
Time Required
5 - 10 minutes
Sections
3
- Battery
- 2 steps
- Case
- 2 steps
- Antenna
- 5 steps
Flags
1
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackNovatel MiFi 2200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the rear cover by pressing down on the cover and pulling it away from the device.
Remove the rear cover by pressing down on the cover and pulling it away from the device.
1024
Step 2
- Place your finger on the back of the battery located near the edge of the device.
- Push your finger into the battery and lift up to pop the battery out of the device.
Place your finger on the back of the battery located near the edge of the device.
Push your finger into the battery and lift up to pop the battery out of the device.
Step 3
Case
- Using a metal spudger, pry open the device around the seam between the front and back cover.
- It may be difficult to split apart, so use force with caution.
- It may seem like you are breaking the device, but you will only be breaking the adhesive lining that keeps the device sealed.
Using a metal spudger, pry open the device around the seam between the front and back cover.
It may be difficult to split apart, so use force with caution.
It may seem like you are breaking the device, but you will only be breaking the adhesive lining that keeps the device sealed.
Step 4
- Once the seal has been broken all the way around, open the cases using your hands.
Once the seal has been broken all the way around, open the cases using your hands.
Step 5
Antenna
- To disconnect the antenna, pull up on the antenna’s connection to the circuit board until it pops off.
To disconnect the antenna, pull up on the antenna’s connection to the circuit board until it pops off.
Step 6
- Carefully pull out the antenna along the edge of the device.
- There is adhesive applied to the antenna, so it may not easily detach.
Carefully pull out the antenna along the edge of the device.
There is adhesive applied to the antenna, so it may not easily detach.
Step 7
- Reconnect your new antenna to the circuit board in the same position described in step 3.
Reconnect your new antenna to the circuit board in the same position described in step 3.
Step 8
- Re-lay antenna around the edge and over the adhesive.
- The antenna can be fitted back into several small recesses along the groove that it was originally inside.
Re-lay antenna around the edge and over the adhesive.
The antenna can be fitted back into several small recesses along the groove that it was originally inside.
Step 9
- Apply double-sided stick tape to the inner top and bottom halves of the device along the seam that was previously unsealed.
- Snap the two halves together along the adhesive line to reconnect it as it previously was.
Apply double-sided stick tape to the inner top and bottom halves of the device along the seam that was previously unsealed.
Snap the two halves together along the adhesive line to reconnect it as it previously was.
With a new antenna, your device should be transmitting a signal as expected. Keep in mind that you will need adhesive tape to keep the device firmly together.
Cancel: I did not complete this guide.
Author
with 7 other contributors
Carissah
Member since: 04/15/2012
147 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 7-36, Maness Spring 2012
Member of Cal Poly, Team 7-36, Maness Spring 2012
CPSU-MANESS-S12S7G36
5 Members
5 Guides authored