Difficulty
Easy
Steps
4
Time Required
5 - 8 minutes
Sections
2
- Nostalgia GCM200 Disassembly
- 3 steps
- Power Cable
- 1 step
Flags
1
Missed a Step
Oops! This guide is currently missing some important steps.
BackNostalgia GCM-200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Nostalgia GCM200 Disassembly
- Remove the two 1.3 mm Phillips #2 screws.
- Remove the S6 spanner screw.
- Carefully place these three screws somewhere safe to use later in reassembly.
Remove the two 1.3 mm Phillips #2 screws.
Remove the S6 spanner screw.
Carefully place these three screws somewhere safe to use later in reassembly.
1024
Step 2
- Split the device in half to expose the internal parts of the device.
- Again, there are two more Phillips screws to remove.
Split the device in half to expose the internal parts of the device.
Again, there are two more Phillips screws to remove.
Step 3
- Remove the two screws from both sides of the heating coil.
Remove the two screws from both sides of the heating coil.
Step 4
Power Cable
- Remove (flexible) plastic sleeves from the inside end of the power cable.
- You might want to use force, pull out while shaking it.
Remove (flexible) plastic sleeves from the inside end of the power cable.
You might want to use force, pull out while shaking it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Praful Busa
Member since: 06/25/2017
267 Reputation
2 Guides authored
Badges:
14
+11 more badges
Team
UW Tacoma, Team S1-G4, Liner Summer 2017
Member of UW Tacoma, Team S1-G4, Liner Summer 2017
UWT-LINER-SU17S1G4
4 Members
5 Guides authored