Nostalgia Electrics Rhp 310 Power Switch Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Power Switch
6 steps

Flags

BackNostalgia Electrics RHP-310
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Power Switch

Unplug the popper.
Remove the plastic lid by lifting the lid up.

Unplug the popper.

Remove the plastic lid by lifting the lid up.

1024

Step 2

Lay the popper on its side.
Remove the five 12mm Philips #2 screws around the perimeter of the base with the Phillips #2 phillips head screwdriver.
Remove the two 15mm Philips #2 screws in the center of the base with the Phillips #2 phillips head screwdriver.
Save the screws you remove from the base in a safe place. They will be needed to reattach the housing to the base.

Lay the popper on its side.

Remove the five 12mm Philips #2 screws around the perimeter of the base with the Phillips #2 phillips head screwdriver.

Remove the two 15mm Philips #2 screws in the center of the base with the Phillips #2 phillips head screwdriver.

Save the screws you remove from the base in a safe place. They will be needed to reattach the housing to the base.

Step 3

Flip the base to view the interior surface of the base.
Unscrew the two screws (10 mm Philips #2 screws) from the base.
Remove the base and set it aside.

Flip the base to view the interior surface of the base.

Unscrew the two screws (10 mm Philips #2 screws) from the base.

Remove the base and set it aside.

Step 4

Locate the power switch connected to the side of the housing.
Carefully pinch the sides of the power switch.
Push the power button up and out of the housing.

Locate the power switch connected to the side of the housing.

Carefully pinch the sides of the power switch.

Push the power button up and out of the housing.

Step 5

Now that the power switch is removed from the housing, you must remove the wires connected to the power switch.
Use the plastic opening tool to gently pry the wires loose from the power switch.
The wires should easily pop out from the power switch.

Now that the power switch is removed from the housing, you must remove the wires connected to the power switch.

Use the plastic opening tool to gently pry the wires loose from the power switch.

The wires should easily pop out from the power switch.

Step 6

Remove the power switch from the device.
You can now replace the power switch if necessary.

Remove the power switch from the device.

You can now replace the power switch if necessary.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 9 other contributors

                    Dana Clarke

Member since: 09/26/2012

50 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 16-57, Forte Fall 2012                        

                                                  Member of Cal Poly, Team 16-57, Forte Fall 2012 



                    CPSU-FORTE-F12S16G57                     


                                            5 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team