Difficulty
Easy
Steps
4
Time Required
15 minutes
Sections
2
- Device base
- 2 steps
- Stand
- 2 steps
Flags
0
BackNostalgia Electrics PCM805
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unscrewing the base
- Unplug the device before following this guide.
- First, place the device on its side, making sure the switch is not facing down.
- Remove the eight 12mm Phillips #02 screws from the base.
Unplug the device before following this guide.
First, place the device on its side, making sure the switch is not facing down.
Remove the eight 12mm Phillips #02 screws from the base.
1024
Step 2
- Gently separate the panel from the device.
- Be sure not to tug at the wires that are still connected.
Gently separate the panel from the device.
Be sure not to tug at the wires that are still connected.
Step 3
Stand
- Locate the four 10mm Phillips #02 screws on the inside of the panel.
Locate the four 10mm Phillips #02 screws on the inside of the panel.
Step 4
- Remove the screw of the foot you plan to replace.
- Place your finger on the back of the the foot you are unscrewing for support.
Remove the screw of the foot you plan to replace.
Place your finger on the back of the the foot you are unscrewing for support.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Carlton
Member since: 01/13/2015
660 Reputation
5 Guides authored
Badges:
13
+10 more badges
Team
USF Tampa, Team 3-5, Hickman Winter 2015
Member of USF Tampa, Team 3-5, Hickman Winter 2015
USFT-HICKMAN-W15S3G5
5 Members
8 Guides authored
