Nostalgia Electrics Pcm805 Power Switch Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 15 minutes

Sections

Device base
2 steps
Power Switch
5 steps

Flags

BackNostalgia Electrics PCM805
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Unscrewing the base

Unplug the device before following this guide.
First, place the device on its side, making sure the switch is not facing down.
Remove the eight 12mm Phillips #02 screws from the base.

Unplug the device before following this guide.

First, place the device on its side, making sure the switch is not facing down.

Remove the eight 12mm Phillips #02 screws from the base.

1024

Step 2

Gently separate the panel from the device.
Be sure not to tug at the wires that are still connected.

Gently separate the panel from the device.

Be sure not to tug at the wires that are still connected.

Step 3

              Power Switch

Locate the switch/wire assembly inside the device.

Locate the switch/wire assembly inside the device.

Step 4

Pull back the insulation sleeves to expose the connector heads.

Pull back the insulation sleeves to expose the connector heads.

Step 5

Note the color of each wire and the order you remove them.
Using a pair of pliers, firmly grip the base of the wire.
Be sure to grip where the connector meets the wire and not where the connector covers the switch prong.
Pull the wire straight out of the switch.
Repeat this step for each wire.

Note the color of each wire and the order you remove them.

Using a pair of pliers, firmly grip the base of the wire.

Be sure to grip where the connector meets the wire and not where the connector covers the switch prong.

Pull the wire straight out of the switch.

Repeat this step for each wire.

Step 6

Using pliers, pinch tabs at the top and bottom of switch.
While pinching the tabs, push the switch until the tabs are on the outside of the device.

Using pliers, pinch tabs at the top and bottom of switch.

While pinching the tabs, push the switch until the tabs are on the outside of the device.

Step 7

Remove the switch from the device.

Remove the switch from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Carlton

Member since: 01/13/2015

660 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       USF Tampa, Team 3-5, Hickman Winter 2015                        

                                                  Member of USF Tampa, Team 3-5, Hickman Winter 2015 



                    USFT-HICKMAN-W15S3G5                     


                                            5 Members                     


                                            8 Guides authored

Manuela Velez - Dec 12, 2017

The red light turns on but the disk isnt spinning or heating up and when the out let has power

Introduction#

What you need#

Team#

Introduction

What you need

Team