Difficulty

Difficult

Steps

8

Time Required

                          15 - 20 minutes

Sections

2

  • Back Cover
  • 5 steps
  • Speaker
  • 3 steps

Flags

0

  • BackNortel Networks i2004 IP

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Flip the phone over to view the back.
  • Remove the power and phone cords.

Flip the phone over to view the back.

Remove the power and phone cords.

1024

Step 2

  • Remove the seven 8mm Phillips #2 screws.

Remove the seven 8mm Phillips #2 screws.

Step 3

  • Lift up the back cover slowly because there are still wires attached to the circuit board.
  • Lifting the back cover should not require a lot of force; simply lift with your fingertips.

Lift up the back cover slowly because there are still wires attached to the circuit board.

Lifting the back cover should not require a lot of force; simply lift with your fingertips.

Step 4

  • Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

Step 5

  • Remove the six 8mm Phillips #2 screws.
  • Pull the speaker phone cover straight up.

Remove the six 8mm Phillips #2 screws.

Pull the speaker phone cover straight up.

Step 6

              Speaker
  • Lift the speaker straight up.
  • The speaker may need to be slightly wiggled in order to loosen and remove.

Lift the speaker straight up.

The speaker may need to be slightly wiggled in order to loosen and remove.

Step 7

  • Cut the red and white wires as close to the speaker as possible.
  • Wire cutters are preferred, but normal scissors are fine too.

Cut the red and white wires as close to the speaker as possible.

Wire cutters are preferred, but normal scissors are fine too.

Step 8

  • Solder wires to new speaker.

Solder wires to new speaker.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Elizabeth

Member since: 01/21/2012

160 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 10-35, Amido Winter 2012                        

                                                  Member of Cal Poly, Team 10-35, Amido Winter 2012 



                    CPSU-AMIDO-W12S10G35                     


                                            4 Members                     


                                            10 Guides authored