Nook Hd Antenna Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          15 - 30 minutes            

Sections

1

• Antenna
• 8 steps

Flags

0

• BackNook HD+

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Antenna               

• Pry the front frame off of the nook by wedging the plastic opening piece between the frame and the nook.

Pry the front frame off of the nook by wedging the plastic opening piece between the frame and the nook.

1024

Step 2

              Remove the screws               

• Remove every visible screw from the front of the nook using the T-4 attachment for the screwdriver in the iFixit screwdriver kit.

Remove every visible screw from the front of the nook using the T-4 attachment for the screwdriver in the iFixit screwdriver kit.

Step 3

              Remove the chassis               

• Carefully remove the center chassis from the bottom frame.

Carefully remove the center chassis from the bottom frame.

Step 4

              Dettatch battery               

• Detach the battery ribbon from the motherboard.

Detach the battery ribbon from the motherboard.

Step 5

              Flip the center chassis               

• Flip the center chassis so that the screen is facing down, and the hole is positioned in the bottom right corner.

Flip the center chassis so that the screen is facing down, and the hole is positioned in the bottom right corner.

Step 6

              Remove the antenna part 1               

• Remove the wire from the attachment on the motherboard (this wire un-clips).

Remove the wire from the attachment on the motherboard (this wire un-clips).

Step 7

              Remove the antenna part 2               

• Apply soldering iron to the wire where it connects on the frame side. Remove wire when the solder is molten.

Apply soldering iron to the wire where it connects on the frame side. Remove wire when the solder is molten.

Step 8

              Place new antenna.               

• Replace new antenna following all the steps in reverse.

Replace new antenna following all the steps in reverse.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Elijah Gonsalves                     

Member since: 10/24/2014

1,028 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       UMass Dartmouth, Team 2-3, Duarte Fall 2014                        

                                                  Member of UMass Dartmouth, Team 2-3, Duarte Fall 2014 



                    UMASSD-DUARTE-F14S2G3                     


                                            5 Members                     


                                            10 Guides authored