Nook Color Battery Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          10 - 15 minutes            

Sections

3

• Back Cover
• 2 steps
• Front Cover
• 3 steps
• Battery
• 3 steps

Flags

2

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

• BackNook Color

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Cover               

• Remove the two 3.8 mm screws located in the back right corner of the device using the T5 Torx screwdriver.

Remove the two 3.8 mm screws located in the back right corner of the device using the T5 Torx screwdriver.

1024

Step 2

• Pry off the back cover with the plastic opening tool. Go around the device with the tool to ensure complete detachment.

Pry off the back cover with the plastic opening tool. Go around the device with the tool to ensure complete detachment.

Step 3

              Front Cover               

• Remove the ten 4.0 mm screws from the device’s perimeter using the T5 Torx screwdriver.

Remove the ten 4.0 mm screws from the device’s perimeter using the T5 Torx screwdriver.

Step 4

• Pry off the front panel using the plastic opening tool.

Pry off the front panel using the plastic opening tool.

Step 5

• Lift up on the connectors to disconnect them using the plastic opening tool.

Lift up on the connectors to disconnect them using the plastic opening tool.

Step 6

              Battery               

• Remove the tape which holds the wiring to the battery using a plastic opening tool.

Remove the tape which holds the wiring to the battery using a plastic opening tool.

Step 7

• On the back side of the middle panel, pry the battery using the plastic opening tools.
• Use of force is necessary since the battery is glued down.

On the back side of the middle panel, pry the battery using the plastic opening tools.

Use of force is necessary since the battery is glued down.

Step 8

• Slide the connecting wire through the opening of where the battery was placed.

Slide the connecting wire through the opening of where the battery was placed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    John Goly                     

Member since: 01/20/2015

490 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       USF Tampa, Team 11-5, Blackwell Winter 2015                        

                                                  Member of USF Tampa, Team 11-5, Blackwell Winter 2015 



                    USFT-BLACKWELL-W15S11G5                     


                                            3 Members                     


                                            14 Guides authored