Difficulty

Difficult

Steps

6

Time Required

                          10 minutes

Sections

2

  • Nokia X Disassembly Prerequisites
  • 4 steps
  • USB Port
  • 2 steps

Flags

0

  • BackNokia X

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Nokia X Disassembly Prerequisites
  • Remove the back cover of the device by applying light pressure toward the outer rim and display.

Remove the back cover of the device by applying light pressure toward the outer rim and display.

1024

Step 2

  • Remove 7 (size 4 M1 43.5) and 4(size 6 M2 64.5) screws using P5 hex screwdriver.
  • The M2 screws are shown in red.
  • The M1 screws are shown in orange.

Remove 7 (size 4 M1 43.5) and 4(size 6 M2 64.5) screws using P5 hex screwdriver.

The M2 screws are shown in red.

The M1 screws are shown in orange.

Step 3

  • Gently separate the display from the chassis.
  • Slowly spread the display and chassis until the inside of the device is reachable.
  • Do not pull apart.

Gently separate the display from the chassis.

Slowly spread the display and chassis until the inside of the device is reachable.

Do not pull apart.

Step 4

  • Using the spudger tool, release the top flex ribbon from the light swap package.

Using the spudger tool, release the top flex ribbon from the light swap package.

Step 5

              USB Port
  • Again, using a spudger tool, release the rear facing camera from the light swap display.
  • Carefully remove the light swap display from the chassis by applying pressure to the circuit board.

Again, using a spudger tool, release the rear facing camera from the light swap display.

Carefully remove the light swap display from the chassis by applying pressure to the circuit board.

Step 6

  • Using a soldering iron, desolder they broken USB port.
  • Solder your replacement USB port onto the light swap package.

Using a soldering iron, desolder they broken USB port.

Solder your replacement USB port onto the light swap package.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 2 other contributors 


                    Josh Perino

Member since: 03/04/2017

415 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       IUPUI, Team S7-G7, Wilson Spring 2017                        

                                                  Member of IUPUI, Team S7-G7, Wilson Spring 2017 



                    IUPUI-WILSON-S17S7G7                     


                                            3 Members                     


                                            8 Guides authored