Difficulty

Moderate

Steps

10

Time Required

                          10 - 25 minutes

Sections

3

  • Battery
  • 4 steps
  • Keypad
  • 2 steps
  • Display
  • 4 steps

Flags

0

  • BackNokia N70

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Orient the phone as shown.
  • Press the button with the plastic opening tool and slide the back case downward relative to the phone.

Orient the phone as shown.

Press the button with the plastic opening tool and slide the back case downward relative to the phone.

1024

Step 2

  • Remove the battery cover by lifting it away from the phone.

Remove the battery cover by lifting it away from the phone.

Step 3

  • Insert the plastic opening tool into the marked space.
  • Lift up the side of the battery closest to the bottom edge of the phone using the plastic opening tool.

Insert the plastic opening tool into the marked space.

Lift up the side of the battery closest to the bottom edge of the phone using the plastic opening tool.

Step 4

  • Remove the battery from the phone.

Remove the battery from the phone.

Step 5

              Keypad
  • Insert the plastic opening tool in the marked areas in between the front and back covers.
  • Pry each corner with the plastic opening tool until the front case completely detaches.

Insert the plastic opening tool in the marked areas in between the front and back covers.

Pry each corner with the plastic opening tool until the front case completely detaches.

Step 6

  • Orient the phone so that the keypad is facing you.
  • Remove the keypad by lifting it away from the phone.

Orient the phone so that the keypad is facing you.

Remove the keypad by lifting it away from the phone.

Step 7

              Display
  • Using a torx T6 screwdriver remove the six 15 mm torx screws.

Using a torx T6 screwdriver remove the six 15 mm torx screws.

Step 8

  • Separate the front panel of the phone by pulling the bottom of the panel at a 45 degree angle.

Separate the front panel of the phone by pulling the bottom of the panel at a 45 degree angle.

Step 9

  • Lift the bottom of the display circuit board up and locate the ribbon connection located where the two circuit boards intersect.
  • Remove the ribbon connection that connects the two circuit boards.

Lift the bottom of the display circuit board up and locate the ribbon connection located where the two circuit boards intersect.

Remove the ribbon connection that connects the two circuit boards.

Step 10

  • While pulling back each of the clamps marked in the image, lift out each side of the screen independently.
  • Be careful when using the plastic prying tool to not scratch the display.

While pulling back each of the clamps marked in the image, lift out each side of the screen independently.

Be careful when using the plastic prying tool to not scratch the display.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      7 other people completed this guide.

Author

                                      with 5 other contributors 


                    Justin

Member since: 10/12/2011

975 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team 6-2, Regan Fall 2011                        

                                                  Member of Cal Poly, Team 6-2, Regan Fall 2011 



                    CPSU-REGAN-F11S6G2                     


                                            4 Members                     


                                            10 Guides authored