Difficulty
Easy
Steps
9
Time Required
3 minutes
Sections
3
- Motherboard
- 6 steps
- Display
- 1 step
- Speaker
- 2 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackNokia Lumia 925
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Motherboard
- Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.
- Pull out the holder until it is completely separate.
- Something like a paperclip will work if there are no tweezers available.
Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.
Pull out the holder until it is completely separate.
Something like a paperclip will work if there are no tweezers available.
1024
Step 2
- Slide a plastic opening tool under the back cover.
- Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.
- Some pins are facing the opposite way from the others.
Slide a plastic opening tool under the back cover.
Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.
Some pins are facing the opposite way from the others.
Step 3
- Remove the 3 screws using the T7 Torx screwdriver.
- Unclip the black tab connector.
Remove the 3 screws using the T7 Torx screwdriver.
Unclip the black tab connector.
Step 4
- Remove the silver metal cover.
- Be careful of the tape under the right square side of the panel. Using a spudger helps.
Remove the silver metal cover.
Be careful of the tape under the right square side of the panel. Using a spudger helps.
Step 5
- Unclip the two orange tabs.
- Remove the four silver screws using the T5 Torx screwdriver.
Unclip the two orange tabs.
Remove the four silver screws using the T5 Torx screwdriver.
Step 6
- Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.
Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.
Step 7
Display
- Push the screen from the inside of the phone.
- Pull the screen off.
- Slide the electronic strip through the small opening.
Push the screen from the inside of the phone.
Pull the screen off.
Slide the electronic strip through the small opening.
Step 8
Speaker
- Locate the grey speaker/camera cover.
- Carefully remove the cover with either a pair of tweezers or your fingers.
Locate the grey speaker/camera cover.
Carefully remove the cover with either a pair of tweezers or your fingers.
Step 9
- With a pair of tweezers, gently remove the orange colored tab closest to the speaker.
With a pair of tweezers, gently remove the orange colored tab closest to the speaker.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Guillermo Lara
Member since: 09/18/2018
391 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
University of North Texas, Team S4-G6, Raign Fall 2018
Member of University of North Texas, Team S4-G6, Raign Fall 2018
UNT-RAIGN-F18S4G6
4 Members
10 Guides authored