Difficulty
Moderate
Steps
11
Time Required
Suggest a time??
Sections
4
- Motherboard
- 6 steps
- Display
- 1 step
- Speaker
- 2 steps
- Front Camera
- 2 steps
Flags
2
Better Introduction
Improve this guide by completing or revising its introduction.
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackNokia Lumia 925
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Motherboard
- Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.
- Pull out the holder until it is completely separate.
- Something like a paperclip will work if there are no tweezers available.
Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.
Pull out the holder until it is completely separate.
Something like a paperclip will work if there are no tweezers available.
1024
Step 2
- Slide a plastic opening tool under the back cover.
- Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.
- Some pins are facing the opposite way from the others.
Slide a plastic opening tool under the back cover.
Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.
Some pins are facing the opposite way from the others.
Step 3
- Remove the 3 screws using the T7 Torx screwdriver.
- Unclip the black tab connector.
Remove the 3 screws using the T7 Torx screwdriver.
Unclip the black tab connector.
Step 4
- Remove the silver metal cover.
- Be careful of the tape under the right square side of the panel. Using a spudger helps.
Remove the silver metal cover.
Be careful of the tape under the right square side of the panel. Using a spudger helps.
Step 5
- Unclip the two orange tabs.
- Remove the four silver screws using the T5 Torx screwdriver.
Unclip the two orange tabs.
Remove the four silver screws using the T5 Torx screwdriver.
Step 6
- Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.
Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.
Step 7
Display
- Push the screen from the inside of the phone.
- Pull the screen off.
- Slide the electronic strip through the small opening.
Push the screen from the inside of the phone.
Pull the screen off.
Slide the electronic strip through the small opening.
Step 8
Speaker
- Locate the grey speaker/camera cover.
- Carefully remove the cover with either a pair of tweezers or your fingers.
Locate the grey speaker/camera cover.
Carefully remove the cover with either a pair of tweezers or your fingers.
Step 9
- With a pair of tweezers, gently remove the orange colored tab closest to the speaker.
With a pair of tweezers, gently remove the orange colored tab closest to the speaker.
Step 10
Front Camera
- Pull at the orange section until it becomes loose.
- It is located in the upper leftmost section of the phone behind the front camera.
Pull at the orange section until it becomes loose.
It is located in the upper leftmost section of the phone behind the front camera.
Step 11
- Pull vertically on the same orange section until the front camera comes out.
- The front camera as well as the speaker may come out after the last step so be careful.
Pull vertically on the same orange section until the front camera comes out.
The front camera as well as the speaker may come out after the last step so be careful.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
O'Ryan Lacour
Member since: 09/18/2018
85 Reputation
1 Guide authored
Badges:
2
Team
University of North Texas, Team S4-G6, Raign Fall 2018
Member of University of North Texas, Team S4-G6, Raign Fall 2018
UNT-RAIGN-F18S4G6
4 Members
10 Guides authored