Difficulty

Moderate

Steps

7

Time Required

                          2 minutes

Sections

2

  • Motherboard
  • 6 steps
  • Display
  • 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackNokia Lumia 925

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Motherboard
  • Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.
  • Pull out the holder until it is completely separate.
  • Something like a paperclip will work if there are no tweezers available.

Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.

Pull out the holder until it is completely separate.

Something like a paperclip will work if there are no tweezers available.

1024

Step 2

  • Slide a plastic opening tool under the back cover.
  • Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.
  • Some pins are facing the opposite way from the others.

Slide a plastic opening tool under the back cover.

Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.

Some pins are facing the opposite way from the others.

Step 3

  • Remove the 3 screws using the T7 Torx screwdriver.
  • Unclip the black tab connector.

Remove the 3 screws using the T7 Torx screwdriver.

Unclip the black tab connector.

Step 4

  • Remove the silver metal cover.
  • Be careful of the tape under the right square side of the panel. Using a spudger helps.

Remove the silver metal cover.

Be careful of the tape under the right square side of the panel. Using a spudger helps.

Step 5

  • Unclip the two orange tabs.
  • Remove the four silver screws using the T5 Torx screwdriver.

Unclip the two orange tabs.

Remove the four silver screws using the T5 Torx screwdriver.

Step 6

  • Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.

Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.

Step 7

              Display
  • Push the screen from the inside of the phone.
  • Pull the screen off.
  • Slide the electronic strip through the small opening.

Push the screen from the inside of the phone.

Pull the screen off.

Slide the electronic strip through the small opening.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Guillermo Lara

Member since: 09/18/2018

391 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       University of North Texas, Team S4-G6, Raign Fall 2018                        

                                                  Member of University of North Texas, Team S4-G6, Raign Fall 2018 



                    UNT-RAIGN-F18S4G6                     


                                            4 Members                     


                                            10 Guides authored