Nokia Lumia 920 Back Panel Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Back panel
5 steps

Flags

BackNokia Lumia 920
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Remove the Bottom Screws

Make sure the phone is off.
Use the T5 screwdriver to remove the two 8.6mm long screws, located at the bottom of the phone. (Head size is 2.5mm)

Make sure the phone is off.

Use the T5 screwdriver to remove the two 8.6mm long screws, located at the bottom of the phone. (Head size is 2.5mm)

1024

Step 2

Use the smallest Torx screwdriver or another small poking tool and push into the hole on the SIM card slot. The plastic SIM protective piece should pop out quite easily.
Put that plastic piece aside.

Use the smallest Torx screwdriver or another small poking tool and push into the hole on the SIM card slot. The plastic SIM protective piece should pop out quite easily.

Put that plastic piece aside.

Step 3

Once both screws on the bottom are removed, and the plastic SIM protective piece is removed, gently push on the outside of the screen.
The screen should become separated using little force. And should like the pictures shown once complete.

Once both screws on the bottom are removed, and the plastic SIM protective piece is removed, gently push on the outside of the screen.

The screen should become separated using little force. And should like the pictures shown once complete.

Step 4

This step may be easier to remove the battery first, but it is not mandatory.
Place the spudger tool or flat plastic tool on top of the ribbon cable to avoid damaging it when prying up on the metal clip.
Use a plastic opening tool, or gently use a small metal flat-head screwdriver to pry up the metal clip. (It is recommended to use a plastic tool; However, if the opening tool does not work or fit into the small opening underneath the clip, use the flat-head.)

This step may be easier to remove the battery first, but it is not mandatory.

Place the spudger tool or flat plastic tool on top of the ribbon cable to avoid damaging it when prying up on the metal clip.

Use a plastic opening tool, or gently use a small metal flat-head screwdriver to pry up the metal clip. (It is recommended to use a plastic tool; However, if the opening tool does not work or fit into the small opening underneath the clip, use the flat-head.)

Step 5

Once the metal clip is removed, gently pry up on the ribbon cable connection, located underneath the metal clip you have just removed.

Once the metal clip is removed, gently pry up on the ribbon cable connection, located underneath the metal clip you have just removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      14 other people completed this guide.

Author

                                      with 4 other contributors

                    Jonathan

Member since: 10/31/2014

1,492 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UMass Dartmouth, Team 4-2, Miles Fall 2014                        

                                                  Member of UMass Dartmouth, Team 4-2, Miles Fall 2014 



                    UMASSD-MILES-F14S4G2                     


                                            2 Members                     


                                            7 Guides authored

nick - Feb 25, 2019

useless - doesnt show detail

Introduction#

What you need#

Team#

Introduction

What you need

Team