Difficulty
Moderate
Steps
8
Time Required
30 minutes
Sections
1
- Display Assembly
- 8 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackNokia Lumia 630/635
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Video Overview
Step 1
BATTERY, SIM AND MEMORY CARDS
- Switch off the phone.
- Remove the battery and any installed SIM and memory cards.
- Remove the black tape near to the loudspeaker.
Switch off the phone.
Remove the battery and any installed SIM and memory cards.
Remove the black tape near to the loudspeaker.
1024
Step 2
SCREWS
- Remove the 9x Torx T4 screws.
- Two of them are with the same head size but with a different length.
Remove the 9x Torx T4 screws.
Two of them are with the same head size but with a different length.
Step 3
REAR COVER / BEZEL
- Use a plastic opening tool to remove the back cover.
- Careful unhook the display assembly flex cable.
Use a plastic opening tool to remove the back cover.
Careful unhook the display assembly flex cable.
Step 4
TESTING THE NEW SPARE PART
- Insert wisdom here.
Insert wisdom here.
Step 5
DISPLAY ASSEMBLY STEP 1
- Put some scotch tape to prevent the glass from scattering.
- Use a hot gun or hair dryer and warm the glass to soften the adhesive.
Put some scotch tape to prevent the glass from scattering.
Use a hot gun or hair dryer and warm the glass to soften the adhesive.
Step 6
DISPLAY ASSEMBLY STEP 2
- Start the separating from the upper right corner, where you have an hole in the middle frame.
- Use plastic tool to prevent the middle frame from scratches.
- Work slowly, you can cut your fingers.
Start the separating from the upper right corner, where you have an hole in the middle frame.
Use plastic tool to prevent the middle frame from scratches.
Work slowly, you can cut your fingers.
Step 7
MIDDLE FRAME
- Clean the middle farme.
- Put adhesive tape 3MM.
- Be careful, don’t cover the technological openings on the middle frame (for the light sensor, earpiece, etc.).
- It’s easier if you order the spare part together with an adhesive tape.
- Install the display assembly.
Clean the middle farme.
Put adhesive tape 3MM.
Be careful, don’t cover the technological openings on the middle frame (for the light sensor, earpiece, etc.).
It’s easier if you order the spare part together with an adhesive tape.
Install the display assembly.
Step 8
- That’s all.
- .
- .
- .
- .
- .
- .
- Did you do it successfully?
That’s all.
.
Did you do it successfully?
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
ZFix
Member since: 12/09/2013
187,195 Reputation
330 Guides authored
Badges:
35
+32 more badges
Team
Master Techs
Member of Master Techs
Community
310 Members
1,168 Guides authored
beatriz_ibre - Jul 24, 2017
Reply
Exactly what I needed! Step by step detailed instructions along with what tools I would need. Heating it up took longer than expected & it took me longer than 30 min, but I actually set aside 2 hours to replace my screen. Woohoo I finally I have a new screen & I did it all on my own…well with the amazing help from ZFix ;D
Roneil Mcintosh - Jun 6, 2018
Reply
how to fix the display