Difficulty
Moderate
Steps
5
Time Required
10 - 20 minutes
Sections
1
- Display Assembly
- 5 steps
Flags
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackNokia Lumia 2520
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
This guide will demonstrate the steps needed to safely remove the display assembly for replacement.
What you need
Step 1
Display Assembly
- Apply heat pad to each side of the device.
- When using any heat pad please use some form of padded gloves so you don’t burn you fingers.
- Microwave the pad for 30 seconds so an ample amount of heat is given on all four sides. Do not microwave more than once every two minutes.
Apply heat pad to each side of the device.
When using any heat pad please use some form of padded gloves so you don’t burn you fingers.
Microwave the pad for 30 seconds so an ample amount of heat is given on all four sides. Do not microwave more than once every two minutes.
1024
Step 2
- Insert the pick between the glass to separate the glass from the device. You can also use the suction cups to help lift the glass.
- When pulling the screen off the chassis, be careful not to cut the ribbon cable that connects the screen to the logic board.
- Take your time to pry open the screen from the chassis as you can easily break the screen or crack it.
Insert the pick between the glass to separate the glass from the device. You can also use the suction cups to help lift the glass.
When pulling the screen off the chassis, be careful not to cut the ribbon cable that connects the screen to the logic board.
Take your time to pry open the screen from the chassis as you can easily break the screen or crack it.
Step 3
- Pull the ribbon cable out from the connection port on the board.
- Move on the step 4 to remove the ribbon connection from the screen.
Pull the ribbon cable out from the connection port on the board.
Move on the step 4 to remove the ribbon connection from the screen.
Step 4
- Use the plastic pry tool to remove both of the connections.
Use the plastic pry tool to remove both of the connections.
Step 5
- Set aside the screen and the display assembly for repair.
Set aside the screen and the display assembly for repair.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Daniel Chevalier
Member since: 09/05/2018
121 Reputation
1 Guide authored
Badges:
2
Team
Gateway, Team S1-G4, Luster Fall 2018
Member of Gateway, Team S1-G4, Luster Fall 2018
GCC-LUSTER-F18S1G4
5 Members
5 Guides authored