Nokia 8290 Adhesive White Film Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          8 minutes

Sections

Front Cover
1 step
Circuit Board
2 steps
Adhesive White Film
2 steps

Flags

BackNokia 8290
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Front Cover

Locate the small button on the top of the phone.
Depress the button.
With your other hand, pull the front cover away from the phone.

Locate the small button on the top of the phone.

Depress the button.

With your other hand, pull the front cover away from the phone.

1024

Step 2

              Circuit Board

Remove all six 5.3 mm long T6 screws.
Remove the circuit board/faceplate sub-assembly from the back of the phone.
Take care to place screws in a safe location.

Remove all six 5.3 mm long T6 screws.

Remove the circuit board/faceplate sub-assembly from the back of the phone.

Take care to place screws in a safe location.

Step 3

Using your fingers, pull the small plastic tab away from the circuit board/faceplate sub-assembly.
Rotate the faceplate away from the circuit board.
Gently remove the faceplate from the circuit board, taking care to not break the small plastic tab on the other side of the sub-assembly.

Using your fingers, pull the small plastic tab away from the circuit board/faceplate sub-assembly.

Rotate the faceplate away from the circuit board.

Gently remove the faceplate from the circuit board, taking care to not break the small plastic tab on the other side of the sub-assembly.

Step 4

              Adhesive White Film

Hold the faceplate with the adhesive film facing upwards.
Use the spudger to pry the adhesive film away. This can be done by working the tool back and forth underneath the film.
It is easiest to begin in the upper left corner.

Hold the faceplate with the adhesive film facing upwards.

Use the spudger to pry the adhesive film away. This can be done by working the tool back and forth underneath the film.

It is easiest to begin in the upper left corner.

Step 5

Continue to loosen the film with the spudger.
Once the film has been mostly loosened, you can peel away the film.
Once the film has been removed, the microphone may fall out, if so, place it aside until all other repairs are finished.

Continue to loosen the film with the spudger.

Once the film has been mostly loosened, you can peel away the film.

Once the film has been removed, the microphone may fall out, if so, place it aside until all other repairs are finished.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Austin Culberson

Member since: 10/22/2012

78 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Clemson, Team 15-3, Benson Fall 2012                        

                                                  Member of Clemson, Team 15-3, Benson Fall 2012 



                    CLEM-BENSON-F12S15G3                     


                                            3 Members                     


                                            21 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team