Difficulty
Moderate
Steps
9
Time Required
5 - 10 minutes
Sections
2
- Battery
- 2 steps
- Motherboard
- 7 steps
Flags
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Better Introduction
Improve this guide by completing or revising its introduction.
BackNokia 6085h
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Flip over the phone so that the back is facing up.
- Pressing your thumb against the back cover, slide the cover off of the phone.
Flip over the phone so that the back is facing up.
Pressing your thumb against the back cover, slide the cover off of the phone.
1024
Step 2
- Remove the phone’s battery.
Remove the phone’s battery.
Step 3
Motherboard
- Use the iFixit opening tool to pry out the two tabs at the top corners of the battery compartment.
Use the iFixit opening tool to pry out the two tabs at the top corners of the battery compartment.
Step 4
- Gently pull off the hinge cap from the top of the phone by hand.
Gently pull off the hinge cap from the top of the phone by hand.
Step 5
- Use a T6 Torx screwdriver to remove the four 7.6 mm screws at the corners of the battery compartment.
Use a T6 Torx screwdriver to remove the four 7.6 mm screws at the corners of the battery compartment.
Step 6
- Open the phone and turn it on its side. You will see a seam around the Nokia’s side.
- Use the iFixit opening tool to run along this seam to pop the clips holding the casing to the frame.
Open the phone and turn it on its side. You will see a seam around the Nokia’s side.
Use the iFixit opening tool to run along this seam to pop the clips holding the casing to the frame.
Step 7
- Use your hand to gently pull off the back panel from the bottom half of the phone.
Use your hand to gently pull off the back panel from the bottom half of the phone.
Step 8
- Close the phone and place it on a flat surface.
- Use the plastic opening tool or your finger to lift up the motherboard from the bottom casing.
- Be careful when pulling up the board; there is still a ribbon cable attached to the back of the board.
Close the phone and place it on a flat surface.
Use the plastic opening tool or your finger to lift up the motherboard from the bottom casing.
Be careful when pulling up the board; there is still a ribbon cable attached to the back of the board.
Step 9
- Find the underside of the motherboard and locate the ribbon cable that attaches the board to the rest of the phone. Use the plastic opening tool to slowly detach the ribbon cable connector, then pull the motherboard away from the frame.
Find the underside of the motherboard and locate the ribbon cable that attaches the board to the rest of the phone. Use the plastic opening tool to slowly detach the ribbon cable connector, then pull the motherboard away from the frame.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 9 other contributors
Andrew
Member since: 10/04/2010
397 Reputation
4 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team 4-46, Amido Fall 2010
Member of Cal Poly, Team 4-46, Amido Fall 2010
CPSU-AMIDO-F10S4G46
4 Members
14 Guides authored