Difficulty
Moderate
Steps
7
Time Required
5 - 10 minutes
Sections
2
- Battery
- 2 steps
- Front LCD Display
- 5 steps
Flags
1
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackNokia 6085h
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The front LCD display is the screen that displays the images of your phone. When an LCD display is damaged or broken, the screen may have a blank white or blue screen. If your screen has been cracked, it may display a white or blue screen with black lines running across. Before starting this guide, check out the Nokia 6085H troubleshooting page.
If replacement of the front LCD display does not restore your screen, this may indicate an issue with the inner LCD display.
What you need
Step 1
Battery
- Flip over the phone so that the back is facing up.
- Pressing your thumb against the back cover, slide the cover off of the phone.
Flip over the phone so that the back is facing up.
Pressing your thumb against the back cover, slide the cover off of the phone.
1024
Step 2
- Remove the phone’s battery.
Remove the phone’s battery.
Step 3
Front LCD Display
- With the phone closed, run a plastic opening tool along the seam of the top half of the phone.
- Make sure to disconnect each of the five clips before proceeding to the next step.
- There are two clips on each side of the phone and one on the top.
With the phone closed, run a plastic opening tool along the seam of the top half of the phone.
Make sure to disconnect each of the five clips before proceeding to the next step.
There are two clips on each side of the phone and one on the top.
Step 4
- Remove the four 3.2 mm screws from the front panel using a T6 Torx screwdriver.
- The fourth screw is located under a fold in the ribbon cable.
Remove the four 3.2 mm screws from the front panel using a T6 Torx screwdriver.
The fourth screw is located under a fold in the ribbon cable.
Step 5
- Starting in the lower right corner, slowly begin to lift the tape that is holding down the front LCD and cables.
- Be careful around the two ribbon cables attached to the tape. These cables are fragile.
- Lift the tape from the board.
Starting in the lower right corner, slowly begin to lift the tape that is holding down the front LCD and cables.
Be careful around the two ribbon cables attached to the tape. These cables are fragile.
Lift the tape from the board.
Step 6
- Using a plastic opening tool, lift the ribbon cable connection below the front LCD.
Using a plastic opening tool, lift the ribbon cable connection below the front LCD.
Step 7
- Using a plastic opening tool, slowly pry the LCD display from the bottom, releasing it from the glue that is holding it to the board.
Using a plastic opening tool, slowly pry the LCD display from the bottom, releasing it from the glue that is holding it to the board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 11 other contributors
Brett Balcer
Member since: 10/04/2010
240 Reputation
2 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 4-46, Amido Fall 2010
Member of Cal Poly, Team 4-46, Amido Fall 2010
CPSU-AMIDO-F10S4G46
4 Members
14 Guides authored