Difficulty

Easy

Steps

7

Time Required

                          5 minutes

Sections

4

  • Battery
  • 2 steps
  • SIM Card
  • 1 step
  • Keypad
  • 2 steps
  • LCD Screen and Speaker
  • 2 steps

Flags

0

  • BackNokia 6010

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Press the small tab on the bottom of the back of the phone.
  • Push the back case upward towards the power button. The back case will then pop off.
  • It requires some force, so be careful.

Press the small tab on the bottom of the back of the phone.

Push the back case upward towards the power button. The back case will then pop off.

It requires some force, so be careful.

1024

Step 2

  • Lift the battery near the bottom and pry up.

Lift the battery near the bottom and pry up.

Step 3

              SIM Card
  • With one hand, press the ridged tab near the visible side of the SIM card.
  • Slide the card out with your other hand.

With one hand, press the ridged tab near the visible side of the SIM card.

Slide the card out with your other hand.

Step 4

              Keypad
  • Grip the phone on either the sides, the top, or the bottom.
  • Pull the front case away from the rest of the phone.
  • There are no special tabs to keep it in place so it should wiggle free easily.

Grip the phone on either the sides, the top, or the bottom.

Pull the front case away from the rest of the phone.

There are no special tabs to keep it in place so it should wiggle free easily.

Step 5

  • Lift the keypad away from the body of the phone.
  • The keypad is the rubber-backed piece with the number keys.

Lift the keypad away from the body of the phone.

The keypad is the rubber-backed piece with the number keys.

Step 6

              LCD Screen and Speaker
  • Remove the six screws around the front of the phone body with a T6 screwdriver.

Remove the six screws around the front of the phone body with a T6 screwdriver.

Step 7

  • Insert your finger underneath the speaker piece and pry away from the phone body.
  • The plastic layer containing the LCD screen and speaker takes some force to remove.
  • There are 4 plastic tabs which keep it in place, but they are hard to press. Be careful and go tab by tab or use a spudger if you are nervous about using too much force.
  • The LCD and the speaker are attached to the same piece and must be replaced together.

Insert your finger underneath the speaker piece and pry away from the phone body.

The plastic layer containing the LCD screen and speaker takes some force to remove.

There are 4 plastic tabs which keep it in place, but they are hard to press. Be careful and go tab by tab or use a spudger if you are nervous about using too much force.

The LCD and the speaker are attached to the same piece and must be replaced together.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Nicholas Hanne

Member since: 01/20/2010

81 Reputation

                                      8 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Cal Poly, Team 14-45, Regan Winter 2010                        

                                                  Member of Cal Poly, Team 14-45, Regan Winter 2010 



                    CPSU-REGAN-W10S14G45                     


                                            5 Members                     


                                            16 Guides authored

Tobi Hunt - Dec 9, 2022

Reply

Greatly appreciated !!!