Nokia 6010 Microphone Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Battery
2 steps
SIM Card
1 step
Keypad
2 steps
LCD Screen and Speaker
2 steps
Logic Board
2 steps
Microphone
1 step

Flags

BackNokia 6010
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Press the small tab on the bottom of the back of the phone.
Push the back case upward towards the power button. The back case will then pop off.
It requires some force, so be careful.

Press the small tab on the bottom of the back of the phone.

Push the back case upward towards the power button. The back case will then pop off.

It requires some force, so be careful.

1024

Step 2

Lift the battery near the bottom and pry up.

Lift the battery near the bottom and pry up.

Step 3

              SIM Card

With one hand, press the ridged tab near the visible side of the SIM card.
Slide the card out with your other hand.

With one hand, press the ridged tab near the visible side of the SIM card.

Slide the card out with your other hand.

Step 4

              Keypad

Grip the phone on either the sides, the top, or the bottom.
Pull the front case away from the rest of the phone.
There are no special tabs to keep it in place so it should wiggle free easily.

Grip the phone on either the sides, the top, or the bottom.

Pull the front case away from the rest of the phone.

There are no special tabs to keep it in place so it should wiggle free easily.

Step 5

Lift the keypad away from the body of the phone.
The keypad is the rubber-backed piece with the number keys.

Lift the keypad away from the body of the phone.

The keypad is the rubber-backed piece with the number keys.

Step 6

              LCD Screen and Speaker

Remove the six screws around the front of the phone body with a T6 screwdriver.

Remove the six screws around the front of the phone body with a T6 screwdriver.

Step 7

Insert your finger underneath the speaker piece and pry away from the phone body.
The plastic layer containing the LCD screen and speaker takes some force to remove.
There are 4 plastic tabs which keep it in place, but they are hard to press. Be careful and go tab by tab or use a spudger if you are nervous about using too much force.
The LCD and the speaker are attached to the same piece and must be replaced together.

Insert your finger underneath the speaker piece and pry away from the phone body.

The plastic layer containing the LCD screen and speaker takes some force to remove.

There are 4 plastic tabs which keep it in place, but they are hard to press. Be careful and go tab by tab or use a spudger if you are nervous about using too much force.

The LCD and the speaker are attached to the same piece and must be replaced together.

Step 8

              Logic Board

Slide the rubber power button away from the body of the phone.
The power button is the rubber piece on the top of the phone.

Slide the rubber power button away from the body of the phone.

The power button is the rubber piece on the top of the phone.

Step 9

Insert a finger between the phone body and logic board.
The logic board is the green plastic piece with circuitry attached.
Pull the board away gently.
The board is delicate and contains electronic parts. Be careful while removing it.

Insert a finger between the phone body and logic board.

The logic board is the green plastic piece with circuitry attached.

Pull the board away gently.

The board is delicate and contains electronic parts. Be careful while removing it.

Step 10

              Microphone

Use a spudger or a finger to lift the the microphone off the body of the phone.
The microphone is attached to the phone with glue, but removes easily with a spudger.

Use a spudger or a finger to lift the the microphone off the body of the phone.

The microphone is attached to the phone with glue, but removes easily with a spudger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    Nicholas Hanne

Member since: 01/20/2010

81 Reputation

                                      8 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Cal Poly, Team 14-45, Regan Winter 2010                        

                                                  Member of Cal Poly, Team 14-45, Regan Winter 2010 



                    CPSU-REGAN-W10S14G45                     


                                            5 Members                     


                                            16 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team