Difficulty

Moderate

Steps

5

Time Required

                          15 - 20 minutes

Sections

4

  • Battery
  • 2 steps
  • Frame
  • 1 step
  • Motherboard
  • 1 step
  • Screen
  • 1 step

Flags

0

  • BackNokia 3310 3G

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Using the thumbtab molded on the bottom of the phone, pry the back cover off using either a fingernail or a plastic opening tool.

Using the thumbtab molded on the bottom of the phone, pry the back cover off using either a fingernail or a plastic opening tool.

1024

Step 2

  • There is a molded notch in the white frame of the phone near the top right of the battery. Using either a finger or a plastic opening tool, utilize the notch to lift up on the battery, and remove it from the device.
  • This specific device did not come with a battery.

There is a molded notch in the white frame of the phone near the top right of the battery. Using either a finger or a plastic opening tool, utilize the notch to lift up on the battery, and remove it from the device.

This specific device did not come with a battery.

Step 3

              Frame
  • Using a T5 screwdriver bit, remove the (6) 5.0 mm screws along the outside edge of the frame.
  • Using a metal spudger, wedge the 6 plastic tabs molded into the outer shell away from the frame to lift up and remove it.

Using a T5 screwdriver bit, remove the (6) 5.0 mm screws along the outside edge of the frame.

Using a metal spudger, wedge the 6 plastic tabs molded into the outer shell away from the frame to lift up and remove it.

Step 4

              Motherboard
  • Use a spudger to simultaneously leverage the shell away and the motherboard up from the body of the shell.

Use a spudger to simultaneously leverage the shell away and the motherboard up from the body of the shell.

Step 5

              Screen
  • With the motherboard removed, the only thing holding the screen into place is the snap plug on the back of the motherboard.
  • Using a spudger, leverage the top snap up to disconnect it (photo shows motherboard rotated 90 degrees counterclockwise).

With the motherboard removed, the only thing holding the screen into place is the snap plug on the back of the motherboard.

Using a spudger, leverage the top snap up to disconnect it (photo shows motherboard rotated 90 degrees counterclockwise).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 3 other contributors 


                    Aaron LeBlanc

Member since: 10/24/2018

711 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       UMass Dartmouth, Team S3-G3, Peak Fall 2018                        

                                                  Member of UMass Dartmouth, Team S3-G3, Peak Fall 2018 



                    UMASSD-PEAK-F18S3G3                     


                                            3 Members                     


                                            8 Guides authored

Feyrowan - May 31, 2021

Reply

If you can break the screen without taking it apart, then you must not be human

M. H. - Nov 2, 2021

The Cylons are greeting you.