Difficulty
Moderate
Steps
7
Time Required
5 - 7 minutes
Sections
3
- Battery and Sim Card
- 3 steps
- Front Pannel
- 2 steps
- Circuit Board
- 2 steps
Flags
0
BackNokia 2610
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Battery and Sim Card
- Place your thumb on the middle of the back cover and push it toward the bottom of the phone to slide the cover off.
Place your thumb on the middle of the back cover and push it toward the bottom of the phone to slide the cover off.
1024
Step 2
- Use a plastic opening tool (or your finger) to gently pry the battery out of the battery slot on the back of the phone.
Use a plastic opening tool (or your finger) to gently pry the battery out of the battery slot on the back of the phone.
Step 3
- Lift the metal sim card holder (at the bottom of the battery slot) up and carefully pry the sim card out of its slot with a plastic opening tool or your finger.
- After removal, lower the metal sim card holder into its original position.
Lift the metal sim card holder (at the bottom of the battery slot) up and carefully pry the sim card out of its slot with a plastic opening tool or your finger.
After removal, lower the metal sim card holder into its original position.
Step 4
Front Pannel
- Insert the plastic opening tool into the crack between the front and back panels.
- Gently pry the front cover away from the back cover while sliding the plastic opening tool towards the top of the phone.
Insert the plastic opening tool into the crack between the front and back panels.
Gently pry the front cover away from the back cover while sliding the plastic opening tool towards the top of the phone.
Step 5
- Lift the bottom of the front cover away from the phone.
- Continue lifting until the top of the front cover is fully removed from the phone.
- Note: To replace the Keypad, gently lift it out of the front cover. It is located below the clear viewing window.
Lift the bottom of the front cover away from the phone.
Continue lifting until the top of the front cover is fully removed from the phone.
Note: To replace the Keypad, gently lift it out of the front cover. It is located below the clear viewing window.
Step 6
Circuit Board
- Use the Torx screwdriver with the T6 attachmet to remove the 6 .4 mm screws around the outside of the circuit board.
- Note: Removing the 4 T6 screws around the screen will loosen it, so don’t worry if the screen also separates from the circuit board.
Use the Torx screwdriver with the T6 attachmet to remove the 6 .4 mm screws around the outside of the circuit board.
Note: Removing the 4 T6 screws around the screen will loosen it, so don’t worry if the screen also separates from the circuit board.
Step 7
- Lift the circuit board out of the back cover.
Lift the circuit board out of the back cover.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 5 other contributors
Andrew Wood
Member since: 10/05/2010
336 Reputation
3 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team 7-52, Amido Fall 2010
Member of Cal Poly, Team 7-52, Amido Fall 2010
CPSU-AMIDO-F10S7G52
4 Members
12 Guides authored
