Difficulty

Moderate

Steps

5

Time Required

                          5 - 10 minutes

Sections

2

  • Front and Back Case
  • 4 steps
  • USB Assembly/ Solar Panel
  • 1 step

Flags

0

  • BackNokero SunRay Pro Power Panel

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front and Back Case
  • Turn over the device so that the back of the device is facing up.

Turn over the device so that the back of the device is facing up.

1024

Step 2

  • Insert the first plastic opening tool along the side to pry open the case.
  • Sliding the plastic opening tool, while inserted, along the seam may help the removal process.
  • Use a second plastic opening tool to help separate the remaining seams.

Insert the first plastic opening tool along the side to pry open the case.

Sliding the plastic opening tool, while inserted, along the seam may help the removal process.

Use a second plastic opening tool to help separate the remaining seams.

Step 3

  • There is a long strip of double sided adhesive foam tape that prevents the back case from easily being removed.
  • Pull the back case off by applying steady pressure to remove it from the adhesive foam tape.

There is a long strip of double sided adhesive foam tape that prevents the back case from easily being removed.

Pull the back case off by applying steady pressure to remove it from the adhesive foam tape.

Step 4

  • Use the Phillips precision screwdriver to unscrew the two 5.0 mm Phillips screws from the circuit board.
  • Remove the solar panel and circuit board from the front case.

Use the Phillips precision screwdriver to unscrew the two 5.0 mm Phillips screws from the circuit board.

Remove the solar panel and circuit board from the front case.

Step 5

              USB Assembly/ Solar Panel
  • Solder the two contact points identified by the “S+” and “S-” to disconnect the USB assembly.

Solder the two contact points identified by the “S+” and “S-” to disconnect the USB assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Nicholas Orr

Member since: 01/20/2015

229 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team 9-3, Blackwell Winter 2015                        

                                                  Member of USF Tampa, Team 9-3, Blackwell Winter 2015 



                    USFT-BLACKWELL-W15S9G3                     


                                            3 Members                     


                                            3 Guides authored