Difficulty
Moderate
Steps
5
Time Required
Suggest a time??
Sections
2
- Back Cover
- 3 steps
- LED Panel
- 2 steps
Flags
0
BackNokero N400
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove Battery Cover
- Press down firmly to remove the battery cover and display battery.
- Then remove the battery.
Press down firmly to remove the battery cover and display battery.
Then remove the battery.
1024
Step 2
Unscrew Back Cover
- Remove the 7mm Phillips #1 screw.
Remove the 7mm Phillips #1 screw.
Step 3
Pry Open Back Cover
- Place the plastic opening tool in between the two plastic panels and slowly work your way around the device.
- Unlatch the clips on the inside and pull device apart.
- Some clips will break when forced open.
Place the plastic opening tool in between the two plastic panels and slowly work your way around the device.
Unlatch the clips on the inside and pull device apart.
Some clips will break when forced open.
Step 4
Removing the LED Panel
- With the back cover of the device removed, lightly pull up on the LED assembly to lift it out of its housing.
- The LED assembly will separate into three components; the light board, outer housing, and plastic lens.
With the back cover of the device removed, lightly pull up on the LED assembly to lift it out of its housing.
The LED assembly will separate into three components; the light board, outer housing, and plastic lens.
Step 5
- Set the outer housing and plastic lens aside.
- Take a pair of pliers and cut the red and black wires connected to the light board.
- Make sure to cut just below the light board.
- To install the new light board, you will need to splice or solder the wires to the new light board.
Set the outer housing and plastic lens aside.
Take a pair of pliers and cut the red and black wires connected to the light board.
Make sure to cut just below the light board.
To install the new light board, you will need to splice or solder the wires to the new light board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Kyle Burwell
Member since: 01/20/2015
173 Reputation
1 Guide authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 19-2, Blackwell Winter 2015
Member of USF Tampa, Team 19-2, Blackwell Winter 2015
USFT-BLACKWELL-W15S19G2
4 Members
5 Guides authored